2011-2013 Land Cruiser · Service Manual Vehicle Interior

REMOVAL

Removal / installation · Vehicles built from Sep 2011


1. REMOVE ASSIST GRIP LH

  1. B291735E01
    Using a screwdriver, detach the 2 claws and open the 2 covers.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape

  1. B291736
    Remove the 2 bolts and assist grip.


2. REMOVE DOOR INSIDE HANDLE BEZEL LH

  1. B295796
    Detach the claw and open the cover.

  1. B291737
    Remove the screw.

  1. B291738E01
    Using a screwdriver, detach the 2 claws.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape

  1. Detach the guide and remove the door inside handle bezel in the direction indicated by the arrow in the illustration.


3. REMOVE BACK DOOR TRIM PANEL ASSEMBLY LH

  1. B291739
    Detach the 10 clips and remove the back door trim panel.


4. REMOVE REAR ASSIST GRIP REINFORCEMENT LH

  1. B291740
    Remove the 3 bolts and rear assist grip reinforcement.


5. REMOVE BACK DOOR INSIDE HANDLE ASSEMBLY LH

  1. B291741
    Remove the screw.

  1. Detach the guide and remove the back door inside handle in the direction indicated by the arrow in the illustration.

  1. Disconnect the 2 links from the back door inside handle.


6. REMOVE BACK DOOR SERVICE HOLE COVER LH

  1. B291742
    Disconnect the 2 connectors and detach the 3 clamps.

  1. B292850
    Pull out the 2 links and wire harness from the back door service hole cover, and then remove the back door service hole cover.

    HINT:
    Remove any remaining butyl tape from the back door panel.


7. REMOVE BACK DOOR LOCK ASSEMBLY

  1. B292789E01
    Rotate the snap as shown in the illustration and disconnect the back door lock locking link from the back door lock control assembly.

  1. Disconnect the back door lock cable assembly from the back door remote control assembly.

    Text in Illustration 
    *1
    Snap
    *2
    Back Door Lock Locking Link
    *3
    Back Door Lock Control Assembly
    *4
    Back Door Remote Control Assembly
    *5
    Back Door Lock Cable Assembly

  1. B292790
    Disconnect the 2 connectors.

  1. Using a T30 "TORX" socket wrench, remove the 4 screws and back door lock assembly.

← COMPONENTS (from Sep 2011)INSPECTION (from Sep 2011) →