2011-2013 Land Cruiser · Service Manual Vehicle Interior

INSTALLATION

Removal / installation · Vehicles built from Sep 2011

CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.


1. INSTALL REAR SEAT CUSHION HOLDER BRACKET

HINT:
Use the same procedure to install the rear seat cushion holder bracket on the other side.

  1. Install the rear seat cushion holder bracket with the 2 bolts.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }


2. INSTALL REAR SEAT CUSHION LOCK STRIKER SUB-ASSEMBLY

HINT:
Use the same procedure to install the rear seat cushion lock striker sub-assembly on the other side.

  1. Install the rear seat cushion lock striker with the 2 bolts.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

  1. B292807
    Return the rear floor silencer to its original position.

  1. B292805
    Return the front floor carpet to its original position and attach the fastener.


3. INSTALL REAR SEAT NO. 2 PROTECTOR

HINT:
Use the same procedure to install the rear seat No. 2 protector on the other side.

  1. Attach the 4 claws to install the rear seat No. 2 protector to the rear seat cushion lock striker sub-assembly.


4. INSTALL REAR DOOR SCUFF PLATE LH

B181674
  1. Attach the 3 claws and 4 clips to install the scuff plate.

  1. Install the screw.


5. INSTALL REAR DOOR SCUFF PLATE RH

HINT:
Use the same procedures described for the LH side.


6. INSTALL REAR STEP COVER

B181673

HINT:
Use the same procedure to install the step cover on the other side.

  1. Attach the 2 claws to install the step cover.


7. INSTALL REAR NO. 1 SEAT ASSEMBLY
  1. Place the rear No. 1 seat assembly in the cabin.

    NOTICE:
    Be careful not to damage the vehicle body.

  1. Temporarily install the rear No. 1 seat assembly with the 4 bolts.

  1. B292800E01
    Tighten the 2 bolts in the order shown in the illustration.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

  1. Return the rear No. 1 seat assembly to its original position.

  1. B292799E01
    Tighten the 2 bolts in the order shown in the illustration.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }


8. INSTALL REAR SEAT NO. 2 CUSHION HINGE COVER
  1. Operate the reclining remote control lever knob and fold down the rear No. 1 seat assembly.

  1. Attach the 3 claws to install the rear seat No. 2 cushion hinge cover.


9. INSTALL REAR SEAT NO. 1 CUSHION HINGE COVER
  1. Attach the 3 claws to install the rear seat No. 1 cushion hinge cover.


10. INSTALL REAR SEAT NO. 4 CUSHION HINGE COVER
  1. Return the rear No. 1 seat assembly to its original position.

  1. Attach the 6 claws to install the rear seat No. 4 cushion hinge cover.


11. INSTALL REAR SEAT NO. 3 CUSHION HINGE COVER
  1. Attach the 6 claws to install the rear seat No. 3 cushion hinge cover.

← REASSEMBLY (from Sep 2011)COMPONENTS (from Sep 2011) →