2011-2013 Land Cruiser · Service Manual Vehicle Exterior

REASSEMBLY

Removal / installation · Vehicles built from Sep 2011


1. INSTALL LICENSE PLATE LIGHT ASSEMBLY
  1. Attach the 2 guides and install the 2 license plate light assemblies.

  1. Install the 2 screws.


2. INSTALL REAR LICENSE LIGHT COVER
  1. Attach the 9 claws to install the rear license light cover to the back door outside garnish.


3. INSTALL BACK DOOR OUTSIDE GARNISH
  1. Install the back door outside garnish to the back door No. 2 outside garnish with the 3 screws.


4. INSTALL BACK DOOR OUTSIDE GARNISH PROTECTOR

HINT:
When installing the back door outside garnish protector, heat the back door outside garnish surface using a heat light.

Standard:
Item
Temperature
Back Door Outside Garnish Sub-assembly
20 to 30°C (68 to 86°F)

NOTICE:
Do not heat the back door outside garnish sub-assembly excessively.

  1. Clean the back door outside garnish sub-assembly surface.

    1. Using a heat light, heat the back door outside garnish sub-assembly surface.

    2. Remove the double-sided tape from the back door outside garnish sub-assembly surface.

    3. Wipe off any tape adhesive residue with cleaner.

  1. B292548
    Install a new back door outside garnish protector as shown in the illustration.


5. INSTALL SYMBOL EMBLEM

HINT:
When installing the symbol emblem, heat the vehicle body and symbol emblem using a heat light.

Standard:
Item
Temperature
Vehicle Body
40 to 60°C (104 to 140°F)
Symbol Emblem
20 to 30°C (68 to 86°F)

NOTICE:
Do not heat the vehicle body or symbol emblem excessively.

  1. Clean the vehicle body surface.

    1. Using a heat light, heat the vehicle body surface.

    2. Remove the double-sided tape from the vehicle body.

    3. Wipe off any tape adhesive residue with cleaner.

  1. B292547E01
    Install a new symbol emblem.

    1. Using a heat light, heat the vehicle body and a new symbol emblem.

    2. Remove the peeling paper from the face of the symbol emblem.

      HINT:
      After removing the peeling paper, keep the exposed adhesive free from foreign matter.

    3. Align the boss positions and install the symbol emblem.

      HINT:
      Press the symbol emblem firmly to install it.

      Text in Illustration 
      *1
      Boss

← DISASSEMBLY (from Sep 2011)INSTALLATION (from Sep 2011) →