INSTALLATION
Removal / installation · Vehicles built from Sep 2011
A bolt without a torque specification is shown in the standard bolt chart (Click here).
| 1. INSTALL BACK DOOR OPENER SWITCH ASSEMBLY |
Connect the connector.
Install the back door opener switch assembly with the 2 screws.
- Torque:
- 5.0 N*m{ 51 kgf*cm , 44 in.*lbf }
| 2. INSTALL DOOR OPENING SWITCH SUB-ASSEMBLY (for Face to Face Seat Type) |
Attach the 2 claws to install the door opening switch sub-assembly.
| 3. INSTALL NO. 2 BACK DOOR SERVICE HOLE COVER (for Face to Face Seat Type) |
Connect the connector.

Attach the 4 claws to install service hole cover.
| 4. INSTALL ASSIST GRIP (for Face to Face Seat Type) |
Install the assist grip with the 2 screws.

