2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

Multi-display Power Source Circuit

Circuit diagnosis · Vehicles built from Jan 2012

DESCRIPTION

This circuit provides power to the multi-display assembly.

WIRING DIAGRAM

C260265E01

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. CHECK HARNESS AND CONNECTOR (MULTI-DISPLAY ASSEMBLY - BATTERY AND BODY GROUND)

  1. E239017E07
    Disconnect the multi-display assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F79-13 (GND1) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    F79-12 (+B2) - Body ground
    Always
    11 to 14 V
    F79-23 (IG) - Body ground
    Engine switch on (IG)
    11 to 14 V
    F79-24 (ACC) - Body ground
    Engine switch on (ACC)
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Multi-display Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Stereo Component Amplifier Power Source Circuit (from Jan 2012)Multi-media Interface ECU Power Source Circuit (Sep 2011 – Dec 2011) →