2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

Multi-media Interface ECU Power Source Circuit

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

DESCRIPTION

This circuit provides power to the multi-media interface ECU.

WIRING DIAGRAM

E180194E25

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (INTERFACE ECU - BATTERY AND BODY GROUND)
  1. Disconnect the L41 multi-media interface ECU connector.

  1. E182617E31
    Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    L41-12 (+B) - L41-7 (GND)
    Always
    11 to 14 V
    L41-11 (ACC) - L41-7 (GND)
    Engine switch on (ACC)
    11 to 14 V

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Multi-media Interface ECU)



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. CHECK HARNESS AND CONNECTOR (INTERFACE ECU - NAVIGATION MODULE)
  1. Disconnect the F60 display and navigation module display connector.

  1. Disconnect the L41 multi-media interface ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    L41-11 (ACC) - F60-11 (ACC)
    Always
    Below 1 Ω
    L41-12 (+B) - F60-12 (+B)
    Always
    Below 1 Ω
    L41-7 (GND) - F60-7 (GND)
    Always
    Below 1 Ω
    L41-11 (ACC) - Body ground
    Always
    10 kΩ or higher
    L41-12 (+B) - Body ground
    Always
    10 kΩ or higher
    L41-7 (GND) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE DISPLAY AND NAVIGATION MODULE DISPLAY (Click here)


← Multi-display Power Source Circuit (from Jan 2012)PARTS LOCATION (from Sep 2011) →