Home › Vehicle Exterior › BODY PANEL › ROCKER REAR PANEL
BM2660E _01 Vehicle Exterior _054376 BODY WELD POINT _0264587 ROCKER REAR PANEL F

BODY WELD POINT  ROCKER REAR PANEL  CUT AND JOIN REPLACEMENT SECTIONS  


K127149

REMOVAL


Symbol Meaning
K108818

Remove Weld Points
K108827

Cut and Join Location
K108828

Cut Location for Supply Parts

REMOVAL POINT
1.

After removing the quarter panel, remove the rocker panel No. 3 reinforcement.


K127197C01
2.219,2.625 2.688,3.135 false 2.75,3.146 3.063,3.302 0.313,0.156 10 false *1 1.156,1.167 1.792,1.417 0.635,0.25 10 false 200 (7.84) 4.271,1.917 4.875,2.115 0.604,0.198 10 false 30 (1.18) 6.729,8.521 7.042,8.719 0.313,0.198 10 false *a
*1 Quarter Panel - -
*a mm (in.) - -



INSTALLATION


Symbol Meaning
K108821

Spot Weld
K108823

Plug Weld
K108831

Butt Weld
K108834

Body Sealer

INSTALLATION POINT
1.

Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.

2.

Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)

3.

Before installing a new part, apply body sealer.

HINT:

Apply sealer in an even, continuous bead.


4.

After welding the rocker panel No. 3 reinforcement to the vehicle side, install the quarter panel.

5.

After welding, apply body sealer to the corresponding parts. (See the painting / coating)

6.

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.


K127198C01
2.99,6.969 3.646,8.083 false 3.688,8.042 3.99,8.292 0.302,0.25 10 false *1
*1 Quarter Panel - -