With the quarter panel removed.
REMOVAL / INSTALLATION
| Symbol Meaning | |
|---|---|
|
Remove Weld Points |
|
Remove Weld Points |
|
Remove Weld Points |
|
Plug Weld |
|
Plug Weld |
|
Plug Weld |
Remove the door lock striker retainer and spare wheel bracket upper reinforcement at the same time.
Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.
Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)
*a is only for installation.
After welding, apply body sealer to the corresponding parts. (See the painting / coating)
After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.
| *A | for Standard | *B | RH: w/ Tire Carrier |
| *1 | Door Lock Striker Retainer | *2 | Back Door Opening Lower Reinforcement |
| *3 | Spare Wheel Bracket Upper Reinforcement | - | - |
| *A | for Standard | - | - |
| *A | for Double Swing Out Type | *B | RH |
| *1 | Back Door Opening Reinforcement Lower | *2 | Back Door Opening Side Frame |
| *3 | Back Door Upper Hinge Retainer | *4 | Back Door Check Reinforcement |
| *5 | Back Door lower Hinge Retainer | - | - |
| *A | for Double Swing Out Type | *B | RH |
| *1 | Spare Wheel Carrier | - | - |