Home › Vehicle Exterior › BODY PANEL › ROOF PANEL(for Sliding Roof) › 2014.08–2018.08
BM2660E _01 Vehicle Exterior _054376 BODY WELD POINT _0264606 ROOF PANEL(for Sliding Roof) F

BODY WELD POINT  ROOF PANEL(for Sliding Roof)  ASSEMBLY REPLACEMENT  


K127164

REMOVAL


Symbol Meaning
K108818

Remove Weld Points

REMOVAL POINT
1.

If reusing the roof panel reinforcement, trim the hemming location using a disc sander, etc.


K127224C01
5.073,4.875 5.344,4.531 false 4.958,4.896 5.271,5.052 0.313,0.156 10 false *a
*a Disc Sander - -



INSTALLATION


Symbol Meaning
K108823

Plug Weld
K108834

Body Sealer

INSTALLATION POINT
1.

Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.

2.

Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)

3.

After the roof panel reinforcement is welded to the new parts, install the roof panel to the vehicle side.

4.

Before temporarily installing the new parts, apply body sealer to the windshield header panel, roof panel reinforcement and back door opening frame.

HINT:

Apply just enough sealer for the new parts to make contact.


5.

After welding, apply body sealer to the corresponding parts. (See the painting / coating)

6.

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.


K127225C01
0.656,4.75 0.313,4.125 false 1.583,4.031 1.354,4.271 false 0.198,3.938 0.51,4.094 0.313,0.156 10 false *a 1.573,3.854 1.885,4.01 0.313,0.156 10 false *b
*a Wooden Hammer *b Cloth Tape