Refer to the TOYOTA Repair Manual for each inspection procedure.
PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED
| Replacement Part | Necessary Procedures | Effects / Inoperative Functions When Necessary Procedures are not Performed | Notes |
|---|---|---|---|
| ECM (1UR-FE) | Register VIN. | DTC P0630 is output. | - |
| ECM (1VD-FTV, w/ DPF) | ·
Learning values save ·
Learning values write |
Engine starting | - |
| Engine assembly (1VD-FTV, w/ DPF) | ·
Clear Crank Time Compensation Data ·
Injector compensation code registration ·
Pilot quantity learning |
Engine starting | - |
| Crankshaft position sensor plate (1VD-FTV, w/ DPF) | Clear crank time compensation data | Crank time compensation data compensation amount is same as before replacement, affecting crank time compensation data | - |
| Air fuel ratio sensor (1VD-FTV, w/ DPF) | Clear A/F sensor compensation data | EGR volume is affected | - |
| Fuel supply pump (1VD-FTV, w/ DPF) | Supply pump initialization | Engine startability | - |
| 1VD-FTV, w/ DPF
·
Front exhaust pipe assemblies (DPF catalytic converter) ·
Monolithic converter assemblies (CCo catalytic converter) |
·
Clear DPF thermal deterioration data ·
Learning values write |
Even if catalytic converter is replaced with new one, catalyst record of DPF thermal deterioration stored in ECM is same as before replacement | - |
| Fuel injector (1VD-FTV, w/ DPF) | ·
Injector compensation code registration ·
Pilot quantity learning |
DTC P062F is output | - |
| Fuel injector (1VD-FTV, w/o DPF) | Injector compensation code registration | DTC P1601 is output | - |
| Fuel supply pump (1VD-FTV, w/o DPF) | ECM initialization | Engine starting | - |
| ECM (1VD-FTV, w/o DPF) | ECU communication ID registration | Engine starting | - |
| Distance control ECU | Initialization | Cannot adjust millimeter wave radar sensor | - |
| Millimeter wave radar sensor assembly | Adjusting the radar beam axis | Dynamic radar cruise control system does not operate normally | - |
| Any of shift solenoid valves | Reset memory | Large shift shock | - |
| Transmission wire | Add and adjust the ATF level | Automatic transmission assembly damaged | - |
| Valve body assembly | Add and adjust the ATF level | Automatic transmission assembly damaged | - |
| Reset memory | Large shift shock | - | |
| Oil cooler and oil cooler tube | Add and adjust the ATF level | Large shift shock | - |
| Park/neutral position switch | Adjust the park/neutral position switch | 1.
Back-up light does not turn on 2.
Meter indicator display malfunction 3.
Vehicle undrivable 4.
Shifting not possible |
- |
| Transmission floor shift assembly | Adjust the shift lever position | 1.
Back-up light does not turn on 2.
Meter indicator display malfunction 3.
Vehicle undrivable 4.
Shifting not possible |
- |
| Automatic transmission assembly | Add and adjust the ATF level | Automatic transmission assembly damaged | - |
| Reset memory | Large shift shock | - | |
| Automatic transmission fluid (for AB60F, 3UR-FE) | ATF thermal degradation estimate reset | The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly. | - |
·
Clutch pedal (for LHD) ·
Clutch master cylinder (for LHD) |
Inspect and adjust clutch pedal | ·
Clutch slips ·
Clutch dies not disengage |
- |
·
Clutch pedal (for RHD) ·
Clutch master cylinder (for RHD) |
Inspect and adjust clutch pedal | ·
Clutch slips ·
Clutch dies not disengage |
- |
| Suspension control ECU | Vehicle height offset calibration | Vehicle height sensor date may be affected due to installation position, or vehicle height recognition may be erroneous | After vehicle height offset calibration is performed, it is necessary to calibrate the yaw rate sensor |
| Height control sensor | Vehicle height offset calibration | Vehicle height sensor date may be affected due to installation position, or vehicle height recognition may be erroneous | After vehicle height offset calibration is performed, it is necessary to calibrate the yaw rate sensor |
·
Suspension ·
Underbody components |
·
Steering angle neutral point in memory ·
Yaw rate and G sensor zero point calibration |
·
The brake control and dynamic control systems do not operate properly ·
VGRS system ·
Parking assist monitor system |
Removed/installed or replaced |
| Tire pressure warning ECU and receiver | 1.
Register transmitter IDs 2.
Initialize tire pressure warning system |
·
When DTC detection conditions of "transmitter ID not received" DTC is met, tire pressure warning light blinks for 1 minute, and then illuminates ·
Tire pressure monitoring function |
- |
| Tire pressure warning valve and transmitter | 1.
Register transmitter IDs 2.
Initialize tire pressure warning system |
·
When DTC detection conditions of "transmitter ID not received" DTC is met, tire pressure warning light blinks for 1 minute, and then illuminates ·
Tire pressure monitoring function |
Even if only one wheel is replaced, IDs for all 5 wheels must be registered. |
| Skid control ECU (Master cylinder solenoid) | Deceleration sensor zero point calibration | The brake control system does not operate properly | - |
| Deceleration sensor | 1.
Clearing zero point calibration data 2.
Deceleration sensor sensor zero point calibration |
The brake control system does not operate properly | - |
| Skid control ECU (Master cylinder solenoid) | 1.
Clearing zero point calibration data 2.
Yaw rate and acceleration sensor zero point calibration |
The brake control and dynamic control systems do not operate properly | - |
| Yaw rate sensor assembly | 1.
Clearing zero point calibration data 2.
Yaw rate and acceleration sensor zero point calibration |
The brake control and dynamic control systems do not operate properly | - |
| Vehicle height adjustment | 1.
Clearing zero point calibration data 2.
Yaw rate and acceleration sensor zero point calibration 3.
Steering sensor initialization |
The brake control and dynamic control systems do not operate properly | w/ active height control system |
·
Brake pedal ·
Hydraulic brake booster |
Check brake pedal height | ·
Brake performance problem ·
Delayed stop light illumination or continuous illumination |
- |
·
Parking brake lever ·
Parking brake cable ·
Parking brake assembly |
Adjust parking brake lever travel | ·
Brake drag ·
Brake performance problem ·
Delayed stop light illumination or continuous illumination |
- |
·
Steering control ECU ·
Steering column ·
Steering intermediate shaft ·
Steering actuator assembly |
Calibration | ·
VGRS system ·
DTC output |
- |
| Steering angle sensor | Initialization | ·
VGRS system ·
Other related systems cannot operate properly |
- |
| Steering column | Steering off center adjustment | Steering system does not operate normally | - |
| Multi-media module receiver assembly (w/ G-BOOK system) | Vehicle contract setting | G-BOOK service | If the multi-media module receiver assembly is replaced on vehicles that do not have a contract for the G-BOOK service, perform the vehicle contract setting. |
| Rear television camera | Rear television camera optional axis (Camera position setting) | Vehicle width extension lines and expected course are deviated | Replace or installation angle of the rear television camera changes because of the removal and installation of the rear television camera |
| Side television camera | Side television camera optional axis (Camera position setting) | Vehicle parallel lines and expected course are deviated | Replace or installation angle of the side television camera changes because of the removal and installation of the side television camera |
| Parking assist ECU | ·
Steering angle neutral point in memory ·
Store the left and right maximum steering angles ·
Rear television camera optical axis (Camera position setting) ·
Side television camera optical axis (Camera position setting) |
Parking assist monitor system | Replace or installation angle of the rear television camera changes because of the removal and installation of the rear television camera |
| w/ Entry and Start System:
·
ID code box ·
Steering lock ECU ·
Key ·
Certification ECU |
Registration | ·
Wireless door lock operation ·
Entry operation ·
Engine starting ·
Steering unlock |
Refer to the Service Bulletin for the registration procedure. |
| w/o Entry and Start System:
·
Transponder key ECU ·
ECM ·
Key |
Registration | Engine starting | Refer to the Service Bulletin for the registration procedure. |
| w/o Entry and Start System:
·
Door control transmitter ·
Door control receiver |
Register recognition code | Wireless door lock operation | - |
| Servo motors | Servomotors initialization | Air conditioning system does not operate properly | During initialization, the AUTO indicator light comes on, and then goes off when initialization has finished. |
| for Models with Jam Protection Function on 4 Windows:
·
Front Power window regulator motor LH ·
Front Power window regulator motor RH ·
Rear Power window regulator motor LH ·
Rear Power window regulator motor RH |
Initialize the motor | ·
Auto Operation ·
Jam protection function ·
Power window control system (for Models with Jam Protection Function on 4 Windows) |
- |
| for Models with Jam Protection Function on Driver Door Window Only:
·
Front Power window regulator motor LH (for LHD) ·
Front Power window regulator motor RH (for RHD) |
Initialize the motor | ·
Auto Operation ·
Jam protection function ·
Power window control system (for Models with Jam Protection Function on Driver Door Window Only) |
- |
| Inner rear view mirror | ·
Compass zone setting ·
Compass calibration ·
Register transmitter code |
Direction is not displayed correctly | - |
·
Sliding roof driver gear (Sliding roof ECU) ·
Sliding roof glass |
Initialize sliding roof system | ·
Auto operation ·
Jam protection function ·
Sliding roof operation after engine switch OFF ·
Wireless door lock control function ·
Key-linked operation function (Driver side door only) ·
Entry lock switch-linked operation |
- |
·
Power back door unit ·
Back door lock |
Initialize back door system | Power back door system | - |
| w/ Static Headlight Auto Leveling
·
Headlight leveling ECU ·
Height control sensor LH |
Initialization | Headlight leveling function | - |
| w/ Dynamic Headlight Auto Leveling, w/o Active Height Control Suspension
·
Headlight swivel ECU ·
Height control sensor LH |
Initialization | Headlight leveling function | - |
| Headlight assembly | Adjustment | Beam axis deviation | - |
| Fog light assembly | Adjustment | Beam axis deviation | - |
| Front bumper | Adjustment | Beam axis deviation | - |