Home › General › INTRODUCTION › WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS › 2015.08–2020.06
BM2660E _V1 General _054377 INTRODUCTION _0264614 WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS F

INTRODUCTION  WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS  PROCEDURES NECESSARY WHEN BATTERY TERMINAL IS DISCONNECTED / RECONNECTED  


Refer to the TOYOTA Repair Manual for each inspection procedure.

PROCEDURES NECESSARY WHEN CABLE IS DISCONNECTED/RECONNECTED TO BATTERY TERMINAL


Procedures Necessary when Cable is Disconnected/Reconnected to Battery Terminal
Necessary Procedure Effect or Inoperative Function when Necessary Procedure is not Performed
Initialization of steering angle sensor VGRS system function
Correction of steering angle neutral point Parking assist monitor system function
Multi-terrain monitor system function
Reset back door close position Power back door system

NOTICE:

After the engine switch is turned off, the multi-media module receiver assembly records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least a minute before disconnecting the cable from the negative (-) battery terminal.