Home › Vehicle Exterior › BODY PANEL › ROOF PANEL(for Sliding Roof) › from 2018.08
BM2660E _01 Vehicle Exterior _054376 BODY PANEL _0264606 ROOF PANEL(for Sliding Roof) F

BODY PANEL  ROOF PANEL(for Sliding Roof)  ASSEMBLY REPLACEMENT  


K127164

REMOVAL


Symbol Meaning
K108818

Remove Weld Points

REMOVAL POINT
1.

If reusing the roof panel reinforcement, trim the hemming location using a disc sander, etc.

2.

*a in illustration above indicates where the adhesive is located.

3.

Roughly cut open the panel so that the adhesive can be reached. Cut through the adhesive with a cut chisel to remove the panel.

HINT:

In cases where the adhesive cannot be removed with a cut chisel, heat the adhesive with an industrial heater gun or gas burner taking care not to cause panel deformation by overheating.



K136811C03
4.958,4.667 5.208,4.26 false 2.49,1.708 2.823,1.708 false 6.302,4.115 6.615,3.729 false 4.844,4.677 5.156,4.833 0.313,0.156 10 false *b 2.323,1.615 2.635,1.771 0.313,0.156 10 false *a 6.635,3.583 6.948,3.74 0.313,0.156 10 false *a
*a Disc Sander - -



INSTALLATION


Symbol Meaning
K108823

Plug Weld
K108834

Body Sealer

INSTALLATION POINT
1.

Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.

2.

Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)

3.

After the roof panel reinforcement is welded to the new parts, install the roof panel to the vehicle side.

4.

Before temporarily installing the new parts, apply body sealer to the windshield header panel, roof panel reinforcement and back door opening frame.

HINT:

Apply just enough sealer for the new parts to make contact.


5.

Apply adhesive (3MTM AutomixTM Panel Bonding Adhesive #8115) to the area indicated by *a in the illustration.

HINT:
·

Do not apply adhesive around the plug welding points.

·

Minimize squeeze out in plug welding areas.



6.

After welding, apply body sealer to the corresponding parts. (See the painting / coating)

7.

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.


K142047C03
1.177,4.229 1.521,4.104 false 0.333,4.167 0.417,4.74 false 2.448,1.74 2.833,1.74 false 0.25,3.958 0.563,4.115 0.313,0.156 10 false *b 1.573,3.969 1.885,4.125 0.313,0.156 10 false *c 2.271,1.656 2.583,1.813 0.313,0.156 10 false *a
*b Wooden Hammer *c Cloth Tape