DESCRIPTION
Some of the functions have been changed due to the change in the sensor.
The display has been changed due to the change in the combination meter assembly.
Some of the clearance sonar icon that are displayed on the interruption screen while each camera image is displayed have changed due to the addition of functions for the multi-terrain monitor system.*
*: Models with multi-terrain monitor system
When a sensor detects an obstacle with the shift lever not in P or R, the buzzer can be temporarily muted using the buzzer mute switch in the multi-display assembly.
DETECTION AREA
| *a | Approx. 60 cm (23.6 in.) | *b | Approx. 40 cm (15.8 in.) |
| *c | Approx. 20 cm (7.8 in.) | - | - |
| *a | Approx.160 cm (63 in.) | *b | Approx.150 cm (59 in.) |
| *c | Approx. 100 cm (39.4 in.) | *d | Approx. 20 cm (7.8 in.) |
| *e | Approx. 50 cm (19.7 in.) | - | - |
These detection ranges are applicable when positioning a 60mm (2.4 in.) diameter pole parallel or perpendicular to the ground. The ranges vary depending on the measuring method and type of obstacle.
SYSTEM DIAGRAM
LAYOUT OF MAIN COMPONENTS
| *1 | ECM | *2 | Front Corner Ultrasonic Sensor RH |
| *3 | Front Corner Ultrasonic Sensor LH | *4 | Park/Neutral Position Switch Assembly |
| *5 | Rear Corner Ultrasonic Sensor LH | *6 | Rear Center Ultrasonic Sensor LH |
| *7 | Rear Center Ultrasonic Sensor RH | *8 | Rear Corner Ultrasonic Sensor RH |
| *1 | Multi-display Assembly | *2 | Combination Meter Assembly |
| *3 | Back Sonar or Clearance Sonar Switch Assembly | *4 | Clearance Warning Buzzer Assembly |
| *5 | Multi-media Module Receiver Assembly | *6 | Air Conditioning Amplifier Assembly |
| *7 | Parking Assist ECU | *8 | Central Gateway ECU |
| *9 | Clearance Warning ECU Assembly | - | - |
ULTRASONIC SENSOR
The ultrasonic sensor consists of the microphone that transmits and receives ultrasonic wave and circuit portion.
| *1 | Microphone | - | - |
| *a | A-A Cross Section | - | - |
| *1 | Microphone | - | - |
| *a | A-A Cross Section | - | - |
CLEARANCE WARNING BUZZER
Depending on the detection distance and the detection area, the sound pattern of the clearance warning buzzer will vary.
| Detection Area | Detection Distance cm (in.) | Buzzer Sound Pattern ON/ OFF Time (msec.) | |
|---|---|---|---|
| Front Corner | Long | 60 +/- 6 to 45 +/- 5 (23.6 +/- 2.4 to 17.7 +/- 2.0) | 200 / 200 |
| Middle | 45 +/- 5 to 35 +/- 4 (17.7 +/- 2.0 to 13.8 +/- 1.6) | 100 / 100 | |
| Short | 35 +/- 4 or less (13.8 +/- 1.6 or less) | Continuous Sound / 0 | |
| Rear Corner | Long | 60 +/- 6 to 45 +/- 5 (23.6 +/- 2.4 to 17.7 +/- 2.0) | 200 / 200 |
| Middle | 45 +/- 5 to 35 +/- 4 (17.7 +/- 2.0 to 13.8 +/- 1.6) | 100 / 100 | |
| Short | 35 +/- 4 or less (13.8 +/- 1.6 or less) | Continuous Sound / 0 | |
| Rear Center | Longest | 150 +/- 15 to 80 +/- 8 (59.1 +/- 5.9 to 31.5 +/- 3.1) | 500 / 200 |
| Long | 80 +/- 8 to 65 +/- 7 (31.5 +/- 3.1 to 25.6 +/- 2.8) | 200 / 200 | |
| Middle | 65 +/- 7 to 50 +/- 5 (25.6 +/- 2.8 to 19.7 +/- 2.0) | 100 / 100 | |
| Short | 50 +/- 5 or less (19.7 +/- 2.0 or less) | Continuous Sound / 0 | |
MULTI-INFORMATION DISPLAY
The location of an obstacle and the approximate distance between the vehicle and the obstacle are displayed on the multi-information display.
The number of lines shown on the display changes based on the actual distance and flashes when the distance is short.
| *1 | Front Corner LH | *2 | Front Corner RH |
| *3 | Rear Corner LH | *4 | Rear Center |
| *5 | Rear Corner RH | - | - |
| *a | Yellow | *b | Long |
| *c | Middle | *d | Red |
| *e | Short | *f | Flashes |
| *g | Longest | - | - |
Screens displaying warning messages relating to an ultrasonic sensor malfunction, ultrasonic sensor freezing, or presence of foreign matter on the ultrasonic sensor are displayed on the multi-information display.
| *A | All sensor icons illuminate regardless of which sensor detected the malfunction, freezing or dirt. | - | - |
| *a | Malfunction Warning | *b | Frozen/Dirty Warning |
MULTI DISPLAY
If an obstacle is detected when the multi-terrain monitor system is activated, the approximatedistance between the vehicle and the obstacle is displayed on the multi-display assembly.*
*: Models with multi-terrain monitor system
The distance is displayed by color based on the actual distance to the obstacle. When an obstacle is detected at the long or middle distance, the indicator is yellow. The color changes from yellow to red when the distance becomes short.
| *1 | Front Corner LH | *2 | Front Corner RH |
| *3 | Rear Corner LH | *4 | Rear Center |
| *5 | Rear Corner RH | - | - |
| *a | Clearance Sonar Icon | - | - |
The illustration shown is an example only. The illustration may differ from the actual vehicle screen.
| *1 | Front Corner LH | *2 | Front Corner RH |
| *3 | Rear Corner LH | *4 | Rear Center |
| *5 | Rear Corner RH | - | - |
| *a | Clearance Sonar Icon | - | - |
The illustration shown is an example only. The illustration may differ from the actual vehicle screen.
| *1 | Front Corner LH | *2 | Front Corner RH |
| *3 | Rear Corner LH | *4 | Rear Center |
| *5 | Rear Corner RH | - | - |
| *a | Clearance Sonar Icon | - | - |
The illustration shown is an example only. The illustration may differ from the actual vehicle screen.
The illustration shown is an example only. The illustration may differ from the actual vehicle screen.
When a sensor detects an obstacle with the shift lever not in P or R, the buzzer can be temporarily muted using the buzzer mute switch in the multi-display assembly.
The mute function is canceled if the vehicle speed reaches a certain level.
| *a | Buzzer Mute Switch | - | - |
The illustration shown is an example only. The illustration may differ from the actual vehicle screen.
The display timing and detection distance on the multi-display can be customized.
The illustration shown is an example only. The illustration may differ from the actual vehicle screen.