Home › General › CHASSIS › DIFFERENTIAL
NM2660E _V1 General _054360 CHASSIS _0267097 DIFFERENTIAL UN GENERAL/CONTROL/DETAILS F

CHASSIS  DIFFERENTIAL  GENERAL/CONTROL/DETAILS  SYSTEM OPERATION  


SYSTEM OPERATION


a.

The table below shows how the 4WD control ECU controls the rear differential lock actuator and rear diff. lock indicator light based on the 4WD control ECU signals received from the switches and signals depending on the operation of the differential lock switch.

*1: When the vehicle speed is higher than approximately 8 km/h (5 mph), the 4WD control ECU prohibits shifting in the "LOCK" mode, and blinks the rear diff. lock indicator light.

*2: For models equipped with the manual transmission, when the clutch pedal is being depressed.

Switches and Signal Condition Rear Diff. Rear Diff. Lock Indicator Light
Differential Lock Switch L4 Position Switch Center Differential Lock Switch Vehicle Speed Rear Diff. Lock Detection Switch
Off Off Off Not input Off Free Turn OFF
On Off Off Not input Off Free Blinks 1
On On On 8 km/h (5 mph) or higher Off Free Blinks 1*1
On On On 8 km/h (5 mph) or higher*2 Off During shifting into LOCK mode Blinks 2
On On On 8 km/h (5 mph) or higher*2 On Lock Turn ON

Rear Diff. Lock Indicator Light Blinks Pattern
X133343E01
0.083,0.417 0.583,0.75 0.5,0.333 10 false On 0.083,0.979 0.417,1.229 0.333,0.25 10 false Off 3.833,0.417 4.333,0.75 0.5,0.333 10 false On 3.833,1.302 4.167,1.552 0.333,0.25 10 false Off 0.969,1.656 1.719,1.99 0.75,0.333 10 false 0.5 sec. 1.458,2.167 2.208,2.5 0.75,0.333 10 false 0.5 sec. 4.948,1.656 5.698,1.99 0.75,0.333 10 false 3 sec. 5.635,1.875 6.385,2.208 0.75,0.333 10 false 0.5 sec. 5.24,2.5 5.99,2.75 0.75,0.25 10 false Blinks 2 1.76,2.5 2.51,2.75 0.75,0.25 10 false Blinks 1 6.083,2.313 6.833,2.646 0.75,0.333 10 false 0.5 sec.

HINT:

When the rear diff. lock is in operation, the skid control ECU stops the operation of the brake control (Multi-terrain ABS with EBD) and turns on the ABS warning light.