Home › General › BODY ELECTRICAL › PRE-CRASH SAFETY SYSTEM
NM2660E _V1 General _054361 BODY ELECTRICAL _0267527 PRE-CRASH SAFETY SYSTEM UN GENERAL/CONTROL/DETAILS F

BODY ELECTRICAL  PRE-CRASH SAFETY SYSTEM  GENERAL/CONTROL/DETAILS  SYSTEM OPERATION  


General


a.

Upon receiving signals from the skid control ECU which indicate that a serious skid is occurring or that the brakes have been applied suddenly, the seat belt control ECU retracts the front seat belts to reduce possible injury to the driver and front passenger.

Operation Flow
Y199936E01
0.948,0.135 2.188,0.865 1.24,0.729 4.615,0.396 5.823,0.833 1.208,0.438 0.542,0.646 0.854,0.969 0.313,0.323 10 false Time 1.083,0.188 2.125,0.885 1.042,0.698 10 false Serious Skid or Sudden Braking 0.406,1.344 1.406,1.729 1,0.385 10 false Normal driving 1.688,1.146 2.75,1.865 1.063,0.719 10 false Data processing and judgment 2.927,1.135 3.75,1.823 0.823,0.688 10 false Signal transmission 3.813,1.115 5.094,1.729 1.281,0.615 10 false Motor activation Belt retraction 5.188,1.313 6.75,1.656 1.563,0.344 10 false Belt tension maintained 4.719,0.448 5.76,0.813 1.042,0.365 10 false Collision occurs 1.063,2.448 2.833,2.917 1.771,0.469 10 false Back to normal belt tension 4.448,2.292 5.021,2.969 0.573,0.677 10 false Collision avoided 5.552,2.177 7.146,2.563 1.594,0.385 10 false Pretensioner activated 3.385,3.906 3.708,4.25 0.323,0.344 10 false Low 2.177,3.469 3.729,3.781 1.552,0.313 10 false Load applied to seat belt 3.385,3.052 3.708,3.396 0.323,0.344 10 false High 5.625,4.052 6.083,4.323 0.458,0.271 10 false Time



Serious Vehicle Skid Operation


a.

While the vehicle is traveling at approximately 30 km/h (20 mph) or above, the skid control ECU determines if skid recovery will be difficult based on the signals from the steering angle sensor, yaw rate sensor, and speed sensors.


b.

The skid control ECU sends a seat belt operation request signal to the seat belt control ECU.


c.

The seat belt control ECU determines the seat belt motor operation conditions based on this signal and the front seat buckle switch signal. Then, it retracts the slack in the seat belts by operating the seat belt motors.


d.

The seat belts return to a normal state when the relevant conditions of the vehicle have stabilized.

Y199937E01
0.26,0.448 1.885,1.052 1.625,0.604 10 false Front Seat Buckle Switch (Front Passenger) 0.531,2.875 1.74,3.229 1.208,0.354 10 false Speed Sensors (4) 1.531,5.344 3.135,5.948 1.604,0.604 10 false Front Seat Buckle Switch (Driver) 1.146,3.688 2.354,4.042 1.208,0.354 10 false Steering Sensor 1.063,4.417 2.271,4.771 1.208,0.354 10 false Yaw Rate Sensor 4.115,5.469 5.719,5.958 1.604,0.49 10 false Airbag Sensor Assembly 4.708,3.229 5.292,4.25 0.583,1.021 10 false Network Gateway ECU 2.563,2.01 3.396,2.635 0.833,0.625 10 false Skid Control ECU 4.073,1.052 4.719,2.135 0.646,1.083 10 false Seat Belt Control ECU 5.448,0.573 7,0.917 1.552,0.344 10 false Seat Belt Motor (Driver) 5.51,1.615 6.938,2.313 1.427,0.698 10 false Seat Belt Motor (Front Passenger) 3.281,3.479 3.531,3.729 0.25,0.25 10 false (a) 3.313,4.229 3.563,4.479 0.25,0.25 10 false (a) 2.094,2.833 2.344,3.083 0.25,0.25 10 false (a) 3.5,1.885 3.958,2.104 0.458,0.219 10 false (b), (c) 2.729,0.542 2.979,0.792 0.25,0.25 10 false (c) 3.969,3.406 4.219,3.656 0.25,0.25 10 false (c) 6.563,4.635 6.813,4.885 0.25,0.25 10 false (c) 4.917,1.771 5.167,2.021 0.25,0.25 10 false (c) 4.917,0.573 5.167,0.823 0.25,0.25 10 false (c) 3.5,5.438 3.75,5.688 0.25,0.25 10 false (c) 5.917,5.74 6.792,6.063 0.875,0.323 10 false CAN (V Bus) 2.99,4.698 4.875,5.073 1.885,0.375 10 false CAN (Movement Control Bus)



Sudden Braking Operation


a.

While the vehicle is traveling at approximately 30 km/h (20 mph) or above, the skid control ECU can determine a sudden braking condition based on the signals from the master cylinder pressure sensor, stop light switch, and speed sensors.


b.

At this time, the skid control ECU outputs a seat belt operation request signal to the seat belt control ECU.


c.

The seat belt control ECU determines the seat belt motor operation conditions based on this signal and the front seat buckle switch signal. Then, it retracts the slack in the seat belts by operating the seat belt motors.


d.

The seat belts return to a normal state when the brake pedal is released.

Y199938E01
0.302,0.448 1.896,1.094 1.594,0.646 10 false Front Seat Buckle Switch (Front Passenger) 0.302,1.427 1.896,2.073 1.594,0.646 10 false Master Cylinder Pressure Sensor 0.542,2.344 1.708,2.677 1.167,0.333 10 false Stop Light Switch 0.479,2.906 1.688,3.219 1.208,0.313 10 false Speed Sensors (4) 2.583,2.073 3.375,2.688 0.792,0.615 10 false Skid Control ECU 4.063,1.177 4.729,2.177 0.667,1 10 false Seat Belt Control ECU 5.51,0.635 7.01,0.979 1.5,0.344 10 false Seat Belt Motor (Driver) 5.5,1.635 6.906,2.24 1.406,0.604 10 false Seat Belt Motor (Front Passenger) 4.688,3.26 5.281,4.229 0.594,0.969 10 false Network Gateway ECU 2.354,3.885 4.229,4.375 1.875,0.49 10 false CAN (Movement Control Bus) 5.938,5.76 6.781,6.156 0.844,0.396 10 false CAN (V Bus) 4.156,5.479 5.792,5.896 1.635,0.417 10 false Airbag Sensor Assembly 1.531,5.313 3.177,5.729 1.646,0.417 10 false Front Seat Buckle Switch (Driver) 2.083,2.833 2.26,3.063 0.177,0.229 10 false (a) 2.104,2.313 2.281,2.542 0.177,0.229 10 false (a) 2.073,1.563 2.25,1.792 0.177,0.229 10 false (a) 3.5,1.885 3.938,2.146 0.438,0.26 10 false (b), (c) 2.865,0.552 3.042,0.781 0.177,0.229 10 false (c) 4.917,0.573 5.094,0.802 0.177,0.229 10 false (c) 4.917,1.74 5.094,1.969 0.177,0.229 10 false (c) 3.969,3.375 4.146,3.604 0.177,0.229 10 false (c) 6.521,4.688 6.698,4.917 0.177,0.229 10 false (c) 3.5,5.396 3.677,5.625 0.177,0.229 10 false (c)