Operating Condition
Controls on the pre-crash safety system are performed under the following conditions:
| Operation Condition | Impact Dampening Component |
|---|---|
| Seat Belt Retracting Operation (Sudden Braking Operation/Front or Rear Wheel Skid Tendency Operation) | ·
Front seat belt is buckled. ·
Vehicle speed is approx. 30 km/h (20 mph) or above. ·
Brakes are suddenly applied, or front or rear wheel skid tendency is detected. |
| Seat Belt Retracting Operation (Pre-crash Safety Operation) | ·
Front seat belt is buckled. ·
Vehicle speed is approx. 5 km/h (4 mph) or above. ·
Oncoming vehicle or an obstacle relative speed is approx. 30 km/h (20 mph) or above. |
| Brake Assist Standby Condition | ·
Vehicle speed is approx. 30 km/h (20 mph) or above. ·
Oncoming vehicle or an obstacle relative speed is approx. 30 km/h (20 mph) or above. ·
Brake pedal is depressed. |
Pre-crash Safety Operation
The distance control ECU determines that the possibility of a frontal collision is high based on the signals received from the millimeter wave radar sensor, steering angle sensor, vehicle speed sensor and yaw rate & deceleration sensor.
The distance control ECU determines that an unavoidable collision condition exists based on the signals received from the millimeter wave radar sensor, vehicle speed sensor, steering angle sensor and yaw rate and deceleration sensor.
The distance control ECU outputs a brake assist standby request signal to the skid control ECU.
Upon receiving this signal, the skid control ECU switches the brake assist to the standby mode.
The distance control ECU outputs a seat belt operation request signal to the seat belt control ECU.
The seat belt control ECU determines the seat belt motor operation condition based on this signal and the seat belt buckle switch signal, and retracts the slack in the seat belts by operating the seat belt motors.
If no collision occurs, the seat belts and the brake assist will return to their normal states.