Home › General › BODY ELECTRICAL › WIPER AND WASHER SYSTEM
NM2660E _V1 General _054361 BODY ELECTRICAL _0269832 WIPER AND WASHER SYSTEM UN GENERAL/CONTROL/DETAILS F

BODY ELECTRICAL  WIPER AND WASHER SYSTEM  GENERAL/CONTROL/DETAILS  RAIN SENSING FUNCTION  


GENERAL


a.

The rain sensing function controls the wiper timing in accordance with the amount of raindrops that strikes the windshield when the wiper switch is in the AUTO position.


b.

The windshield wiper ECU controls the timing based on the signal from the rain sensor.



RAIN SENSOR


a.

The rain sensor consists of two LEDs (Light Emitting Diodes) that emit infrared rays, 3 photo diodes that can receive those rays, a lens and rain sensor tape

Y202252C01
1.542,0.365 2.49,0.365 false 1.615,0.615 2.563,0.615 true 1.375,1.146 2.344,1.146 true 4.51,1.094 5.479,1.094 true 1.938,1.5 2.885,1.5 2.885,1.5 2.885,1.156 true 1.354,0.25 1.781,0.635 0.427,0.385 10 false *1 1.406,0.521 1.771,0.781 0.365,0.26 10 false *2 1.177,1.063 1.51,1.354 0.333,0.292 10 false *3 5.531,1.021 6.052,1.396 0.521,0.375 10 false *4 1.76,1.438 2.094,1.729 0.333,0.292 10 false *3
*1 Rain Sensor Tape *2 Lens
*3 Photo Diode *4 LED


HINT:

If the rain sensor tape has been peeled off during a windshield glass replacement, make sure to affix new rain sensor tape. Failure to do so will lead to a system malfunction.



b.

If no raindrops are present in the detection area, the infrared rays emitted by the LED are all reflected from the outer surface of the windshield glass and are received by the photo diode.


c.

If rain is present in the detection area, a portion of the emitted infrared rays penetrate the windshield glass due to the change in the difference of the index of refraction between the glass and the area outside the windshield (difference between air and water). The ability of the windshield glass to reflect all light back inside changes due to the presence of rain. This change of internal reflection due to the presence of water reduces the amount of infrared rays that are received by the photo diode. The amount of this reduction is then used to determine the amount of rain. Thus, this function controls the intermittent, low, and high wiper operation in order to operate the wipers at an optimal wiping timing.

Y202253C01
0.99,2 0.698,2.479 0.698,2.479 1.344,1.99 true 2.677,2.469 2.521,2.01 true 6.156,2.469 6,2.01 true 4.417,2.021 4.125,2.5 4.125,2.5 4.771,2.01 true 0.781,1.219 0.51,0.74 true 4.219,1.24 3.958,0.771 true 5.031,0.948 5.396,0.552 true 5.323,1.135 5.844,0.875 true 2.729,1.823 3.198,1.823 true 3.792,0.635 4.167,0.854 0.375,0.219 10 false *1 0.542,2.479 0.885,2.719 0.344,0.24 10 false *2 2.656,2.49 2.885,2.74 0.229,0.25 10 false *3 3.24,1.75 3.531,2.063 0.292,0.313 10 false *a 5.865,0.781 6.094,0.99 0.229,0.208 10 false *b 5.385,0.406 5.677,0.677 0.292,0.271 10 false *c 3.969,2.5 4.313,2.74 0.344,0.24 10 false *2 6.156,2.5 6.542,2.729 0.385,0.229 10 false *3 0.354,0.625 0.729,0.844 0.375,0.219 10 false *1
*1 Windshield Glass *2 Photo Diode
*3 LED - -
*a Infrared Ray *b Raindrop
*c Penetrated Infrared Ray - -