DESCRIPTION
A memory system is used, depending on the model.
This system can store 3 positions for the driver seat, outer rear view mirror assembly, and steering column assembly respectively.
The driver seat ECU stores seat slide, front vertical, rear vertical, and reclining positions in its memory.
The outer mirror control ECU stores the outer rear view mirror position in its memory.
The multiplex tilt and telescopic ECU stores the tilt and telescopic position in its memory.
The driver seat ECU outputs a signal to each ECU to reproduce the stored settings.
A memory call function, which utilizes the key IDs of the transmitter, is used to memorize and retrieve the optimal driving positions for a person possessing the key.
The memory and recall conditions of this system are as follows.
| Function | Condition |
|---|---|
| Memory | Stores the positions when both conditions below have been met and switch 1, 2, or 3 is pushed while the SET switch is pushed.
·
Engine switch is on (IG). ·
Shift position is P. When the memory setting is completed, the buzzer will sound for approximately 0.5 seconds. |
| Recall | If switch 1, 2, or 3 is pressed when both conditions below have been met, the system operates to adjust the positions.
·
Engine switch is on (IG). ·
Shift position is P. If switch 1, 2, or 3 is pressed when both conditions below have been met and within 30 seconds, the system operates to adjust the positions. ·
Engine switch is off. ·
Driver door is opened. The buzzer sounds for approximately 0.1 seconds once the stored seat position is reproduced. |
LAYOUT OF MAIN COMPONENTS
| *1 | Outer Rear View Mirror Assemblies
·
Mirror Motor |
*2 | ECM |
| *3 | Steering Column Assembly
·
Tilt and Telescopic Motors |
*4 | Park / Neutral Position Switch |
| *5 | Outer Mirror Control ECU | *6 | Front Door Courtesy Light Switch Assembly LH |
| *7 | Memory Switches | *8 | Set Switch |
| *9 | Main Body ECU (Multiplex Network Body ECU) | *10 | Outer Mirror Switch Assembly |
| *11 | Front Power Seat Switch LH
·
Driver Seat ECU |
*12 | Seat Motors |
| *13 | Engine Switch | *14 | Multiplex Tilt and Telescopic ECU |
| *15 | Tilt and Telescopic Switch | - | - |
DRIVER SEAT ECU
The driver seat ECU is built into the front power seat switch.
This ECU effects the main control of the memory system in order to memorize and recall the driver seat position. In addition, the driver seat ECU instructs the outer mirror control ECU, multiplex tilt and telescopic ECU, to start memorizing or recalling their respective positions.
The driver seat position, outer rear view mirror position, and the tilt and telescopic steering position are memorized by their respective ECUs.
The ECUs exchange the information that is necessary for memory control via the CAN.
| *1 | Driver Seat | *2 | Slide and Vertical Power Seat Switch Knob
·
Seat Slide ·
Front Vertical ·
Rear Vertical (Lifter) |
| *3 | Reclining Power Seat Switch Knob | *4 | Front Power Seat Switch LH
·
Driver Seat ECU |
SEAT POSITION DETECTION METHOD
A pulse generation circuit in driver seat ECU converts the driving current pulsations that are generated by the rotation of the motor into pulse signals. These signals are then picked up in order to detect the seat position.