Home › Engine / Hybrid System › 1UR-FE (ENGINE CONTROL) › POWER STEERING OIL PRESSURE SWITCH
RM2660E _51 Engine / Hybrid System _052772 1UR-FE ENGINE CONTROL _0254981 POWER STEERING OIL PRESSURE SWITCH G

1UR-FE ENGINE CONTROL  POWER STEERING OIL PRESSURE SWITCH  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89438A 1.INSPECT POWER STEERING OIL PRESSURE SWITCH

a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Power Steering Pressure.


e.

Start the engine.


f.

Operate the steering wheel while idling and read the value on the GTS.

Standard:
Measurement Condition Specified Condition
Power steering not operating 0 to 2000 kPa (0 to 20 kgf/cm2, 0 to 290 psi)
Power steering operating Value changes from value displayed when power steering not operating


If the result is not as specified, check for DTCs (See page Engine / Hybrid System>1UR-FE (ENGINE CONTROL)>SFI SYSTEM>DTC CHECK / CLEAR). If the power steering system inspection results are normal and a DTC is not output, replace the power steering oil pressure switch.