Home › Engine / Hybrid System › 1UR-FE (ENGINE CONTROL) › SFI SYSTEM › from 2015.08
RM2660E _51 Engine / Hybrid System _052772 1UR-FE ENGINE CONTROL _0254983 SFI SYSTEM D

1UR-FE ENGINE CONTROL  SFI SYSTEM  FREEZE FRAME DATA  


DESCRIPTION


The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was moving or stationary, whether the engine was warmed up or not, whether the air-fuel ratio was lean or rich, as well as other data recorded at the time of a malfunction.

Freeze frame data records the engine conditions (fuel system information, calculated load, engine coolant temperature, fuel trim, engine speed, vehicle speed, etc.) when a malfunction is detected.

HINT:

If it is impossible to duplicate the problem even though a DTC is output, check the freeze frame data.



A103809E94
2.281,0.094 3.156,0.26 0.875,0.167 10 DTC stored 1.25,1 2.031,1.177 0.781,0.177 10 0.5 seconds 0.292,0.979 1.073,1.177 0.781,0.198 10 0.5 seconds 0.365,2.802 2.698,3.083 2.333,0.281 10 Freeze frame data which can be read 2.219,0.979 3,1.177 0.781,0.198 10 0.5 seconds

The ECM records engine conditions in the form of freeze frame data every 0.5 seconds. Using the GTS, 5 separate sets of freeze frame data can be checked.

-

3 data sets from before the DTC was stored

-

1 data set from when the DTC was stored

-

1 data set from after the DTC was stored



These data sets can be used to simulate the condition of the vehicle from around the time of the occurrence of the malfunction. The data may assist in identifying the cause of the malfunction, and in judging whether it was temporary or not.


LIST OF FREEZE FRAME DATA


Refer to "Data List / Active Test" (See page Engine / Hybrid System>1UR-FE (ENGINE CONTROL)>SFI SYSTEM>DATA LIST / ACTIVE TEST).