Home › Engine / Hybrid System › 1UR-FE (ENGINE CONTROL) › SFI SYSTEM › 2014.08–2015.08
RM2660E _51 Engine / Hybrid System _052772 1UR-FE ENGINE CONTROL _0254983 SFI SYSTEM C

1UR-FE ENGINE CONTROL  SFI SYSTEM  P060E  Internal Control Module Throttle Position Performance  


DESCRIPTION

The ECM monitors the input signals of the throttle position sensor No. 1 and stop light switch. As the ECM monitors the input signals of the throttle position sensor No. 1 and the STP signals of the stop light switch, if the input signals and control signals deviate, a DTC is stored.

DTC No. DTC Detection Condition Trouble Area
P060E Either condition is met (1 trip detection logic):
·

There is an ECM main CPU error.

·

There is an ECM sub CPU error.


ECM

CONFIRMATION DRIVING PATTERN

1.

Turn the engine switch off.

2.

Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.

3.

Connect the cable to the negative (-) battery terminal.

4.

Turn the engine switch on (IG) and wait for 16 seconds or more.


PROCEDURE

1.CHECK FOR DTC
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).


c.

Turn the GTS on.



e.

Turn the GTS off.


f.

Turn the engine switch off.


g.

Disconnect the GTS.


h.

Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.


i.

Connect the cable to the negative (-) battery terminal.


j.

Connect the GTS to the DLC3.


k.

Turn the engine switch on (IG) and turn the GTS on.


l.

Wait 16 seconds or more.


m.

Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.


n.

Check for DTCs.

OK:

P060E is not output.




OK

NG