The ECM operates the air pump heater relay (AIR PMP HTR) which causes the air pump heater to operate.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| P144C | Open or short in the air pump heater relay circuit for 5 seconds (1 trip detection logic). | ·
Open or short in air pump heater relay circuit ·
No. 2 Integration Relay (AIR PMP HTR) ·
ECM |
| P144D | Open or short in the air pump heater relay circuit for 5 seconds (1 trip detection logic). | ·
Open or short in air pump heater relay circuit ·
No. 2 Integration Relay (AIR PMP HTR) ·
ECM |
Refer to DTC P0412 (See page Engine / Hybrid System>1UR-FE (ENGINE CONTROL)>SFI SYSTEM>P0412).
Inspect the fuses of circuits related to this system before performing the following inspection procedure.
Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.
Inspect the No. 2 integration relay (AIR PMP HTR) (See page Engine / Hybrid System>1UR-FE (ENGINE CONTROL)>RELAY>ON-VEHICLE INSPECTION).
OK
NG
Remove the No. 2 integration relay (AIR PMP HTR).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1X-1 - Body ground | Always | 11 to 14 V |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1Y-1 - Body ground | Always | 11 to 14 V |
Reinstall the No. 2 integration relay (AIR PMP HTR).
OK
NG
Remove the No. 2 integration relay (AIR PMP HTR).
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1P-10 - C46-60 (HAI1) | Always | Below 1 Ω |
| 1P-10 or C46-60 (HAI1) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1P-10 - C45-60 (HAI1) | Always | Below 1 Ω |
| 1P-10 or C45-60 (HAI1) - Body ground | Always | 10 kΩ or higher |
Reinstall the No. 2 integration relay (AIR PMP HTR).
Reconnect the ECM connector.
OK
NG