Home › Engine / Hybrid System › 1VD-FTV (ENGINE CONTROL) › ECD SYSTEM (w/o DPF) › 2014.08–2015.08
RM2660E _51 Engine / Hybrid System _052773 1VD-FTV ENGINE CONTROL _0254984 ECD SYSTEM(w/o DPF) D

1VD-FTV ENGINE CONTROL  ECD SYSTEM(w/o DPF)  DTC CHECK / CLEAR  


NOTICE:

When the diagnosis system is changed from the normal mode to check mode or vice versa, all DTCs and freeze frame data stored in normal mode are erased. Before changing modes, always check and make a note of DTCs and freeze frame data.


HINT:
·

DTCs which are stored in the ECM can be output on the intelligent tester. The intelligent tester can output current and pending DTCs.

·

The same DTCs are not stored if the ECM does not detect the same malfunction again during a second consecutive driving cycle. However, such malfunctions, detected on only one occasion, are stored as pending DTCs.



CHECK DTC (Using Intelligent Tester)


a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the tester on.


d.

Enter the following menus: Powertrain / Engine / DTC.


e.

Check the DTC(s) and freeze frame data, and then write them down.




CLEAR DTC (Using Intelligent Tester)


a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the tester on.


d.

Enter the following menus: Powertrain / Engine / DTC / Clear.


e.

Press the YES button.



CLEAR DTC (Without using Intelligent Tester)


a.

Perform either one of the following operations.

i.

Disconnect the cable from the negative (-) battery terminal for more than 1 minute.


ii.
A176224E01
0.229,0.163 1.989,0.354 1.760,0.191 10 Engine Room Relay Block: 1.63,0.67 2.293,0.854 0.663,0.184 10 EFI MAIN 1.172,1.446 1.432,0.765 1.432,0.765 1.57,0.765 false

Remove the EFI MAIN fuse from the engine room relay block (located inside the vehicle) for more than 1 minute.