Home › Engine / Hybrid System › 1VD-FTV (ENGINE CONTROL) › CRANKSHAFT POSITION SENSOR
RM2660E _51 Engine / Hybrid System _052773 1VD-FTV ENGINE CONTROL _0254987 CRANKSHAFT POSITION SENSOR A

1VD-FTV ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11301K 1.INSTALL CRANKSHAFT POSITION SENSOR

A102906

a.

Apply a light coat of engine oil to the O-ring.

NOTICE:

When reusing the sensor, inspect the O-ring.

If the O-ring has scratches or cuts, replace the sensor.



b.
A175725

Install the sensor with the bolt.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


c.

Connect the sensor wire harness clamp.


Hide 88320 2.INSTALL COOLER COMPRESSOR ASSEMBLY