Home › Engine / Hybrid System › 1VD-FTV (ENGINE CONTROL) › CRANKSHAFT POSITION SENSOR
RM2660E _51 Engine / Hybrid System _052773 1VD-FTV ENGINE CONTROL _0254987 CRANKSHAFT POSITION SENSOR G

1VD-FTV ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSPECTION  


PROCEDURE

Hide 11301K 1.INSPECT CRANKSHAFT POSITION SENSOR

A163527E01
0.072,0.047 2.672,0.481 2.600,0.434 10 Component without harness connected: (Crankshaft Position Sensor) 0.599,1.732 0.986,1.915 0.387,0.184 10 NE- 2.541,1.743 2.924,1.936 0.383,0.193 10 NE+ 1.47,1.835 0.954,1.835 false 1.951,1.829 2.484,1.829 false

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (NE+) - 2 (NE-) Hot 1630 to 2740 Ω
Cold 2065 to 3225 Ω


NOTICE:

In the table above, the terms "cold" and "hot" refer to the temperature of the sensor. "Cold" means approximately -10 to 50°C (14 to 122°F). "Hot" means approximately 50 to 100°C (122 to 212°F).


If the result is not as specified, replace the sensor.