Home › Engine / Hybrid System › 1VD-FTV (ENGINE CONTROL) › MANIFOLD ABSOLUTE PRESSURE SENSOR › 2014.08–2015.08
RM2660E _51 Engine / Hybrid System _052773 1VD-FTV ENGINE CONTROL _0254990 MANIFOLD ABSOLUTE PRESSURE SENSOR G

1VD-FTV ENGINE CONTROL  MANIFOLD ABSOLUTE PRESSURE SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89421C 1.CHECK DIESEL TURBO PRESSURE SENSOR

U162884E02
1.333,2.146 0.74,2.563 false 2.125,2.115 2.719,2.552 false 0.198,0.135 2.5,0.521 2.302,0.385 10 false Front view of wire harness connector: (to Diesel Turbo Pressure Sensor) 2.771,2.5 3.073,2.698 0.302,0.198 10 false VC 0.479,2.49 0.76,2.698 0.281,0.208 10 false E2 0.354,1.917 0.698,2.104 0.344,0.188 10 false C80

a.

Inspect the power source voltage.

i.

Disconnect the sensor connector.


ii.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
C80-3 (VC) - C80-1 (E2) Engine switch on (IG) 4.5 to 5.5 V



iii.

Turn the engine switch off.


iv.

Connect the sensor connector.



b.

Check the vacuum and pressure.

i.

Connect the intelligent tester to the DLC3.


ii.

Turn the engine switch on (IG) and turn the intelligent tester on.


iii.

Enter the following menus: Powertrain / Engine / Data List / Map and Atmosphere Pressure.


iv.

Read the value.

OK:
Condition Map and Atmosphere Pressure Value
No pressure applied Same as atmospheric pressure
Vacuum applied Becomes vacuum
Pressure applied Becomes pressurized


If the result is not as specified, replace the sensor.