Home › Engine / Hybrid System › 1VD-FTV (ENGINE CONTROL) › DIESEL THROTTLE BODY › 2014.08–2015.08
RM2660E _51 Engine / Hybrid System _052773 1VD-FTV ENGINE CONTROL _0254992 DIESEL THROTTLE BODY G

1VD-FTV ENGINE CONTROL  DIESEL THROTTLE BODY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 26100G 1.INSPECT DIESEL THROTTLE BODY ASSEMBLY

a.

Inspect the diesel throttle valve.

i.

Turn the engine switch on (IG).


ii.

Turn the engine switch off and wait 5 seconds.

HINT:

Be sure to turn off the engine switch before performing this inspection. The fully closed position of the diesel throttle valve is learned when the engine switch is turned off.



iii.

Connect the intelligent tester to the DLC3.


iv.

Turn the engine switch on (IG).


v.

Turn the intelligent tester on.


vi.

Enter the following menus: Powertrain / Engine / Data List / Diesel Throttle / Throttle Sensor Volt % and Throttle Sensor #2 Volt %.


vii.

Check that the value of "Throttle Sensor Volt %, Throttle Sensor #2 Volt %" is within the specification.

Standard Value:
Tester Display Specified Condition
Throttle Sensor Volt % 60 to 80%
Throttle Sensor #2 Volt %


If the result is not as specified, replace the throttle body.


viii.

Enter the following menus: Powertrain / Engine / Data List / All Data / Throttle Close Learning Val.


ix.

Check that the value of "Throttle Close Learning Val" is within the specification.

Standard Throttle Valve Fully Closed:
Tester Display Specified Condition
Throttle Close Learning Val. 14.25 to 21.25 deg


If the result is not as specified, replace the throttle body.