Home › Engine / Hybrid System › 1VD-FTV (ENGINE CONTROL) › VACUUM SWITCHING VALVE(for Engine Mounting)
RM2660E _51 Engine / Hybrid System _052773 1VD-FTV ENGINE CONTROL _0254993 VACUUM SWITCHING VALVE(for Engine Mounting) G

1VD-FTV ENGINE CONTROL  VACUUM SWITCHING VALVE(for Engine Mounting)  INSPECTION  


PROCEDURE

Hide 25860 1.INSPECT NO. 1 VACUUM SWITCHING VALVE ASSEMBLY

a.
U163062E01
0.208,0.461 0.315,0.624 0.107,0.163 10 1 1.583,0.684 1.687,0.831 0.104,0.147 10 2 0.978,0.903 0.608,0.529 0.608,0.529 0.358,0.529 false 1.072,0.937 1.355,0.762 1.355,0.762 1.566,0.762 false 1.168,4.009 1.168,4.259 false 0.737,4.264 1.583,4.416 0.847,0.152 10 Body Ground

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 37 to 44 Ω
1 - Body Ground
2 - Body Ground
Always 10 kΩ or higher


If result is not as specified, replace the vacuum switching valve assembly.


b.

Check the VSV operation.

i.
A176555E01
0.462,1.235 0.583,1.377 0.121,0.142 10 F 1.506,1.339 1.637,1.498 0.132,0.159 10 E 2.034,1.174 2.412,1.358 0.378,0.184 10 Filter 1.33,1.772 1.867,1.931 0.538,0.159 10 Vacuum 0.59,1.308 0.959,1.308 false 1.193,1.417 1.471,1.417 false 2.235,0.903 2.235,1.149 false

When applying vacuum to port E, check that air is sucked into the filter.

If the result is not as specified, replace the vacuum switching valve assembly.


ii.
A176556E03
0.302,1.167 0.365,1.167 0.365,1.167 0.688,1.385 false 0.917,1.542 1.344,1.542 false 0.073,1.5 0.656,1.677 0.583,0.177 10 false Vacuum 0.156,1.083 0.271,1.229 0.115,0.146 10 false F 1.438,1.469 1.625,1.688 0.188,0.219 10 false E

Apply voltage across the terminals.


iii.

When applying vacuum to port F, check that air is sucked into port E.

If the result is not as specified, replace the vacuum switching valve assembly.