Home › Engine / Hybrid System › 1VD-FTV (ENGINE CONTROL) › AIR FUEL RATIO SENSOR
RM2660E _51 Engine / Hybrid System _052773 1VD-FTV ENGINE CONTROL _0255000 AIR FUEL RATIO SENSOR A

1VD-FTV ENGINE CONTROL  AIR FUEL RATIO SENSOR  INSTALLATION  


PROCEDURE

Hide 89467B 1.INSTALL AIR FUEL RATIO SENSOR (for Bank 2)

a.
A271064E01
2.675,1.95 2.855,2.125 0.180,0.175 10 *1 0.6,2.256 0.924,2.431 0.325,0.175 10 SST 1.358,1.052 0.768,2.089 0.768,2.089 0.768,2.237 false

Using SST, install the air fuel ratio sensor to the front exhaust pipe.

SST
09224-00010  

Torque:
without SST : 44 N*m (449 kgf*cm, 32 ft.*lbf)
with SST : 40 N*m (408 kgf*cm, 30 ft.*lbf)

Text in Illustration
*1 Fulcrum Length

HINT:
·

Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). When using a torque wrench with a fulcrum length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

Make sure SST and the wrench are connected in a straight line.




b.
A239462E01
1.835,0.617 2.1,0.282 2.1,0.282 2.195,0.282 false 2.206,0.196 2.370,0.357 0.164,0.160 10 *1

Connect the air fuel ratio sensor connector and attach the clamp.

Text in Illustration
*1 White Tape

HINT:

Make sure that the white tape is in the position shown in the illustration.



Hide 89467B 2.INSTALL AIR FUEL RATIO SENSOR (for Bank 1)

a.
A271063E01
0.653,1.298 0.833,1.472 0.180,0.175 10 *1 2.842,0.997 3.167,1.171 0.325,0.175 10 SST 2.346,1.432 2.73,1.081 2.73,1.081 2.823,1.081 false

Using SST, install the air fuel ratio sensor to the front exhaust pipe.

SST
09224-00010  

Torque:
without SST : 44 N*m (449 kgf*cm, 32 ft.*lbf)
with SST : 40 N*m (408 kgf*cm, 30 ft.*lbf)

Text in Illustration
*1 Fulcrum Length

HINT:
·

Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). When using a torque wrench with a fulcrum length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

Make sure SST and the wrench are connected in a straight line.




b.

Connect the air fuel ratio sensor connector and attach the clamp.


Hide 3.PERFORM AIR FUEL RATIO SENSOR COMPENSATION RESET