Home › Engine / Hybrid System › 1GR-FE (ENGINE CONTROL) › SFI SYSTEM › from 2015.08
RM2660E _51 Engine / Hybrid System _052774 1GR-FE ENGINE CONTROL _0255001 SFI SYSTEM C

1GR-FE ENGINE CONTROL  SFI SYSTEM  P0657  Actuator Supply Voltage Circuit / Open  


DESCRIPTION

The ECM monitors the voltage output to the throttle actuator. This self-check ensures that the ECM is functioning properly. The output voltage is usually 0 V when the ignition switch is turned off. If the output voltage is 7 V or higher when the ignition switch is turned off, the ECM will illuminate the MIL and store this DTC when the ignition switch is turned to ON.

DTC No. DTC Detection Condition Trouble Area
P0657 There is a throttle actuator power supply error (1 trip detection logic). ECM

PROCEDURE

1.CHECK WHETHER DTC OUTPUT RECURS (DTC P0657)
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.



e.

Turn the ignition switch off.


f.

Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.


g.

Connect the cable to the negative (-) battery terminal.


h.

Turn the ignition switch to ON for 10 seconds.


i.

Turn the ignition switch off.


j.

Turn the ignition switch to ON.


k.

Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.


l.

Read the DTCs.

Result
Result Proceed to
P0657 is output A
No DTC is output B



A

B