Home › Engine / Hybrid System › 1GR-FE (ENGINE CONTROL) › SFI SYSTEM
RM2660E _51 Engine / Hybrid System _052774 1GR-FE ENGINE CONTROL _0255001 SFI SYSTEM D

1GR-FE ENGINE CONTROL  SFI SYSTEM  CHECK MODE PROCEDURE  


HINT:

Compared to normal mode, check mode is more sensitive to malfunctions. Therefore, check mode can detect malfunctions that cannot be detected in normal mode.


NOTICE:

All the stored DTCs and freeze frame data are cleared if: 1) the ECM is changed from normal mode to check mode or vice versa; or 2) the ignition switch is turned from ON to ACC or off while in check mode. Before changing modes, always check and note any DTCs and freeze frame data.


CHECK MODE PROCEDURE


a.

Check and ensure the following conditions:

i.

Battery positive voltage 11 V or higher.


ii.

Throttle valve fully closed.


iii.

Shift lever in P or N.


iv.

A/C switch off.



b.

Turn the ignition switch off.


c.

Connect the GTS to the DLC3.


d.

Turn the ignition switch to ON.


e.

Turn the GTS on.


f.

Enter the following menus: Powertrain / Engine and ECT / Utility / Check Mode.


g.

Switch the ECM from normal mode to check mode.


h.
A076900E62
2.052,0.427 3.135,0.656 1.083,0.229 10 false 0.13 seconds 1.927,1.823 3.01,2.052 1.083,0.229 10 false 0.13 seconds 0.177,0.76 0.531,0.958 0.354,0.198 10 false On 0.167,1.531 0.521,1.729 0.354,0.198 10 false Off

Make sure the MIL flashes as shown in the illustration.


i.

Start the engine.


j.

Make sure the MIL turns off.


k.

Simulate the conditions of the malfunction described by the customer.


l.

Check DTCs and freeze frame data using the GTS.