Home › Engine / Hybrid System › 1GR-FE (ENGINE CONTROL) › SFI SYSTEM › from 2015.08
RM2660E _51 Engine / Hybrid System _052774 1GR-FE ENGINE CONTROL _0255001 SFI SYSTEM C

1GR-FE ENGINE CONTROL  SFI SYSTEM  P0630  VIN not Programmed or Mismatch - ECM / PCM  


MONITOR DESCRIPTION

DTC P0630 is stored when the Vehicle Identification Number (VIN) or frame number is not stored in the ECM or the input VIN or frame number is not accurate.

DTC No. DTC Detection Condition Trouble Area
P0630 Either of the following conditions is met (1 trip detection logic):
·

The VIN or frame number is not stored in the ECM.

·

The VIN or frame number written to the ECM is not accurate.


ECM

CAUTION / NOTICE / HINT

HINT:

Read freeze frame data using the GTS. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.


PROCEDURE

1.READ OUTPUT DTC (DTC P0630)
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.


e.

Read the DTCs.

HINT:

If P0630 is output, the VIN or frame number must be written to the ECM using the GTS. However, all DTCs are cleared automatically by the GTS when the VIN or frame number is written. If DTCs other than P0630 are output, troubleshoot them first.


Result:
Result Proceed to
DTC P0630 is output A
DTC P0630 and other DTCs are output B




A

2.INPUT VIN OR FRAME NUMBER

B

2.INPUT VIN OR FRAME NUMBER
a.


NEXT

END