This DTC is stored when a communication error occurs in the ECM.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| P060B | There is an ECM main CPU communication error (1 trip detection logic). | ·
ECM ·
Knock sensor |
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Clear the DTCs (See page Engine / Hybrid System>1GR-FE (ENGINE CONTROL)>SFI SYSTEM>DTC CHECK / CLEAR).
Turn the GTS off.
Turn the ignition switch off.
Disconnect the GTS.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Wait 16 seconds or more.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC P060B is output | B |
| DTC P060B and P0327 or P0328 are output | C |
P060B is not output.
A
B
C