Home › Engine / Hybrid System › 1GR-FE (ENGINE CONTROL) › CRANKSHAFT POSITION SENSOR
RM2660E _51 Engine / Hybrid System _052774 1GR-FE ENGINE CONTROL _0255003 CRANKSHAFT POSITION SENSOR G

1GR-FE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSPECTION  


PROCEDURE

Hide 1.INSPECT CRANKSHAFT POSITION SENSOR

a.
A163612E01
0.056,0 2.573,0.350 2.517,0.350 10 Component without harness connected: (Crankshaft Position Sensor)

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Cold 1630 to 2740 Ω
Hot 2065 to 3225 Ω


NOTICE:

In the table above, the terms "Cold" and "Hot" refer to the temperature of the sensor. "Cold" means approximately -10 to 50°C (14 to 122°F). "Hot" means approximately 50 to 100°C (122 to 212°F).


If the resistance is not as specified, replace the sensor.