Home › Engine / Hybrid System › 1GR-FE (ENGINE CONTROL) › ACCELERATOR PEDAL
RM2660E _51 Engine / Hybrid System _052774 1GR-FE ENGINE CONTROL _0255014 ACCELERATOR PEDAL G

1GR-FE ENGINE CONTROL  ACCELERATOR PEDAL  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 78110K 1.INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY

a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

Enter the following menus: Powertrain / Engine and ECT / Data List / ETCS / Accel Sens. No. 1 Volt % and Accel Sens. No. 2 Volt %.


e.

Read the value displayed on the intelligent tester.

Standard Value:
Tester Display Condition Specified Condition
Accel Sens. No.1 Volt % Released 10 to 22%
Depressed 54 to 86%
Accel Sens. No.2 Volt % Released 12 to 42%
Depressed 66 to 98%


If the result is not as specified, check the accelerator pedal, wire harness or ECM.