Home › Engine / Hybrid System › 1GR-FE (ENGINE CONTROL) › MASS AIR FLOW METER
RM2660E _51 Engine / Hybrid System _052774 1GR-FE ENGINE CONTROL _0255015 MASS AIR FLOW METER G

1GR-FE ENGINE CONTROL  MASS AIR FLOW METER  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:
·

Perform the mass air flow meter inspection according to the procedures below.

·

Only replace the mass air flow meter when the mass air flow value in the Data List (with the engine stopped) is not within the normal operating range or there is foreign matter on the mass air flow meter platinum hot wire (heater).



PROCEDURE

Hide 22204 1.INSPECT MASS AIR FLOW METER

a.

Read the value using the GTS.

NOTICE:
·

Perform the inspection with the vehicle indoors and on a level surface.

·

Perform the inspection of the mass air flow meter while it is installed to the air cleaner case (installed to the vehicle).

·

During the test, do not use the exhaust air duct to apply suction to the exhaust pipe.



i.

Turn the ignition switch to ON.


ii.

Turn the GTS on.


iii.

Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / MAF.


iv.

Wait 30 seconds and read the value on the GTS.

Standard:
Item Condition Specified Condition
MAF
·

Engine not running


·

30 seconds after ignition switch is turned to ON


0.8 g/sec. or less


If the result is not as specified, replace the mass air flow meter.

If the result is within the specified range, inspect the mass air flow meter (See page Engine / Hybrid System>1GR-FE (ENGINE CONTROL)>MASS AIR FLOW METER>INSPECTION).