Home › Engine / Hybrid System › 3UR-FE (ENGINE CONTROL) › CAMSHAFT OIL CONTROL VALVE
RM2660E _51 Engine / Hybrid System _052775 3UR-FE ENGINE CONTROL _0255018 CAMSHAFT OIL CONTROL VALVE G

3UR-FE ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE  INSPECTION  


PROCEDURE

Hide 15340 1.INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 6.9 to 7.9 Ω


If the result is not as specified, replace the oil control valve assembly.


b.
A165597E04
2.566,0.731 2.680,0.893 0.114,0.163 10 1 0.103,0.133 0.282,0.309 0.178,0.176 10 *a 2.867,1.151 2.749,0.821 2.749,0.821 2.699,0.821 false 3.257,0.731 3.371,0.893 0.114,0.163 10 2 3.066,1.151 3.184,0.821 3.184,0.821 3.234,0.821 false

Connect the battery positive (+) lead to terminal 1 and the negative (-) lead to terminal 2, and check the movement of the valve.

OK:
Condition Specified Condition
Battery positive (+) voltage is applied Valve moves in left arrow direction shown in the illustration
Battery positive (+) voltage is cut off Valve moves in right arrow direction shown in the illustration


Text in Illustration
*a Component without harness connected
(Oil Control Valve)

If the result is not as specified, replace the oil control valve assembly. If the valve cannot return properly because of foreign matter, a small pressure leak in the advanced direction may occur and a DTC may be output.