Home › Engine / Hybrid System › 3UR-FE (ENGINE CONTROL) › CAMSHAFT OIL CONTROL VALVE
RM2660E _51 Engine / Hybrid System _052775 3UR-FE ENGINE CONTROL _0255018 CAMSHAFT OIL CONTROL VALVE G

3UR-FE ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 15330B 1.INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

a.

Connect the intelligent tester to the DLC3.


b.

Start the engine and turn the intelligent tester on.


c.

Warm up the engine.


d.

Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the VVT Linear (Bank 1) or Control the VVT Linear (Bank 2) or Control the VVT System (Bank 1) or Control the VVT System (Bank 2) or Control the VVT Exhaust Linear (Bank 1) or Control the VVT Exhaust Linear (Bank 2).


e.

Check the engine speed while operating the Oil Control Valve (OCV) using the intelligent tester.

OK:
Tester Operation Specified Condition
OCV OFF Normal engine speed
OCV ON Soon after OCV switched from OFF to ON, engine idles roughly or stalls


If the result is not as specified, check the oil control valve, wiring and camshaft timing gear.

HINT:
·

Control the VVT Linear (Bank 1): Command to activate exhaust and intake side oil control valves of bank 1 (Control range: Between -128 to 127%).

·

Control the VVT Linear (Bank 2): Command to activate exhaust and intake side oil control valves of bank 2 (Control range: Between -128 to 127%).

·

Control VVT System (Bank 1): Command to activate oil control valve of bank 1 (Control range: ON/OFF).

·

Control VVT System (Bank 2): Command to activate oil control valve of bank 2 (Control range: ON/OFF).

·

Control the VVT Exhaust Linear (Bank 1): Command to activate exhaust side oil control valve of bank 1 (Control range: Between -128 to 127%).

·

Control the VVT Exhaust Linear (Bank 2): Command to activate exhaust side oil control valve of bank 2 (Control range: Between -128 to 127%).