Home › Engine / Hybrid System › 3UR-FE (ENGINE CONTROL) › ECM › 2014.08–2015.08
RM2660E _51 Engine / Hybrid System _052775 3UR-FE ENGINE CONTROL _0255020 ECM A

3UR-FE ENGINE CONTROL  ECM  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 82664A 3.DISCONNECT CONNECTOR HOLDER BLOCK

a.
A176574

Remove the 3 bolts and move the connector holder block so that the ECM can be removed in the next step.


Hide 89661 4.REMOVE ECM

a.
A182753E02
2.105,0.315 2.39,0.506 0.285,0.19 0.786,0.259 0.969,0.420 0.183,0.160 10 *a 1.013,0.343 1.228,0.343 1.228,0.343 1.994,0.747 false 2.168,0.315 2.531,0.477 0.363,0.162 10 *b

Raise the 2 levers while pushing the locks on the 2 levers.

Text in Illustration
*a Lock
*b Push

NOTICE:

Make sure that the lock levers are raised 90° as shown in the illustration before disconnecting the connectors. Failure to do this may cause the connectors to break.



b.

Disconnect the 2 connectors.


c.
A155993

Remove the 4 bolts and ECM.


Hide 5.REMOVE GASKET

a.
A167150

Peel off the gasket.


b.
A185949E02
1.888,1.699 2.130,1.852 0.242,0.154 10 *1 1.446,1.606 1.74,1.783 1.74,1.783 1.836,1.783 false

Spray gasket remover or equivalent on the remaining tape of the gasket.

NOTICE:

When using gasket remover or equivalent, cover the ECM connectors with a cloth.


Text in Illustration
*1 Cloth


c.
A245456

Remove the tape of the gasket without using bladed objects.