Home › Engine / Hybrid System › 3UR-FE (ENGINE CONTROL) › CRANKSHAFT POSITION SENSOR
RM2660E _51 Engine / Hybrid System _052775 3UR-FE ENGINE CONTROL _0255024 CRANKSHAFT POSITION SENSOR A

3UR-FE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11401G 1.INSTALL CRANKSHAFT POSITION SENSOR

a.

Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.

NOTICE:
·

When reusing the sensor, inspect the O-ring.

·

If the O-ring has scratches or cuts, replace the sensor.




b.

Install the sensor with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


c.

Connect the sensor connector.


Hide 19312 2.INSTALL CRANKSHAFT POSITION SENSOR PROTECTOR

a.

Install the sensor protector with the 2 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)