Home › Engine / Hybrid System › 3UR-FE (ENGINE CONTROL) › HEATED OXYGEN SENSOR
RM2660E _51 Engine / Hybrid System _052775 3UR-FE ENGINE CONTROL _0255029 HEATED OXYGEN SENSOR G

3UR-FE ENGINE CONTROL  HEATED OXYGEN SENSOR  INSPECTION  


PROCEDURE

Hide 89465 1.INSPECT HEATED OXYGEN SENSOR

a.
A181937E03
1.912,1.568 2.025,1.746 0.112,0.178 10 1 1.516,1.568 1.616,1.716 0.100,0.148 10 2 1.516,1.968 1.633,2.107 0.117,0.140 10 3 1.911,1.968 2.018,2.119 0.107,0.151 10 4 1.869,3.425 1.989,3.575 0.119,0.150 10 1 1.593,3.425 1.693,3.573 0.100,0.148 10 2 1.593,3.824 1.709,3.964 0.117,0.140 10 3 1.868,3.824 1.975,3.976 0.107,0.151 10 4 0.846,1.24 1.039,1.405 0.193,0.165 10 +B 1.098,1.326 1.184,1.326 1.184,1.326 1.556,1.567 false 2.421,1.24 3.005,1.410 0.584,0.170 10 HT1B*A 2.381,1.326 2.295,1.326 2.295,1.326 1.923,1.567 false 0.905,3.098 1.130,3.263 0.225,0.165 10 +B 1.197,3.184 1.283,3.184 1.283,3.184 1.655,3.425 false 2.417,3.098 2.975,3.268 0.558,0.170 10 HT2B*B 2.377,3.184 2.291,3.184 2.291,3.184 1.919,3.425 false 0.17,0.094 0.409,0.269 0.239,0.174 10 *a

Measure the heater resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (HT1B) - 2 (+B)
(for Bank 1)
20°C (68°F) 11 to 16 Ω
1 (HT2B) - 2 (+B)
(for Bank 2)


Text in Illustration
*A for Bank 1
*B for Bank 2
*a Component without harness connected
(Heated Oxygen Sensor)

If the result is not as specified, replace the sensor.