Home › Engine / Hybrid System › 1GR-FE (ENGINE MECHANICAL) › DRIVE BELT
RM2660E _51 Engine / Hybrid System _052778 1GR-FE ENGINE MECHANICAL _0255054 DRIVE BELT A

1GR-FE ENGINE MECHANICAL  DRIVE BELT  INSTALLATION  


PROCEDURE

Hide 16361A 1.INSTALL FAN AND GENERATOR V BELT

a.
A225650E01
0.302,0.699 0.492,0.890 0.191,0.191 10 *1 1.406,0.69 1.597,0.881 0.191,0.191 10 *2 0.858,1.033 1.049,1.224 0.191,0.191 10 *3 2.33,0.461 2.521,0.652 0.191,0.191 10 *3 3.107,0.555 3.297,0.746 0.191,0.191 10 *4 2.875,1.452 3.065,1.643 0.191,0.191 10 *5 2.206,1.538 2.397,1.729 0.191,0.191 10 *6 1.407,1.421 1.598,1.612 0.191,0.191 10 *7 2.634,0.936 2.824,1.127 0.191,0.191 10 *8 2.594,1.024 2.338,1.024 false

Set the V belt onto every part.

Text in Illustration
*1 Vane Pump
*2 Water Pump
*3 No. 2 Idler
*4 Generator
*5 Cooler Compressor or Idler Pulley
*6 No. 1 Idler
*7 Crankshaft
*8 V-ribbed Belt Tensioner


b.

While turning the belt tensioner counterclockwise, remove the pin.

NOTICE:

Make sure that the V belt is properly installed to each pulley.



c.

Check that the belt fits properly in the ribbed grooves.

HINT:

Make sure to check by hand that the belt has not slipped out of the grooves on the bottom of the pulley.