Home › Engine / Hybrid System › 1VD-FTV (ENGINE MECHANICAL) › CYLINDER HEAD
RM2660E _51 Engine / Hybrid System _052779 1VD-FTV ENGINE MECHANICAL _0255071 CYLINDER HEAD A

1VD-FTV ENGINE MECHANICAL  CYLINDER HEAD  REASSEMBLY  


PROCEDURE

Hide 11117E 1.INSTALL NO. 1 STRAIGHT SCREW PLUG (w/ DPF)

a.

Install a new gasket with the No. 1 straight screw plug.

Torque:
18 N*m (184 kgf*cm, 13 ft.*lbf)


Hide 23699A 2.INSTALL NOZZLE HOLDER CLAMP SEAT (w/o DPF)

a.

Install the nozzle holder clamp seat.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 13734 3.INSTALL VALVE SPRING SEAT

A075638

Hide 13711A 4.INSTALL VALVE STEM OIL SEAL

a.
A385745E01
0.573,0.99 1.208,0.979 true 2.865,1.125 2.865,1.271 true 2.542,1.969 2.729,1.969 2.729,1.969 2.896,1.583 true 0.26,0.896 0.719,1.094 0.458,0.198 10 true SST 0.708,2.271 0.979,2.469 0.271,0.198 10 true *a 2.208,2.26 2.479,2.458 0.271,0.198 10 true *b 3.083,0.771 3.24,0.969 0.156,0.198 10 false A 2.344,1.885 2.5,2.083 0.156,0.198 10 false *1 2.75,1.302 3.052,1.531 0.302,0.229 10 false SST

Apply a light coat of engine oil to the valve guide bush.

Text in Illustration
*1 Cylinder Head
*a CORRECT
*b INCORRECT


b.

Using SST, push in a new valve stem oil seal.

SST
09201-41020  


c.

Check that the protrusion height of the valve stem oil seal labeled A in the illustration is as specified.

Standard protrusion height:

Below 14.7 mm (0.579 in.)



Hide 5.INSTALL VALVE

a.
A075640E07
2.188,0.552 3.24,0.729 1.052,0.177 10 false 50 mm (1.97 in.)

Apply plenty of engine oil to the tip area of the valve as shown in the illustration.


b.
A164542E03
0.604,1.823 1.188,1.823 false 2.833,0.24 3.104,0.323 3.104,0.323 3.104,0.427 true 0.292,1.75 0.583,1.896 0.292,0.146 10 true SST 2.99,0.448 3.281,0.594 0.292,0.146 10 false SST

Place the cylinder head on a wooden block.


c.

Install the valve, inner compression spring and valve spring retainer to the cylinder head.

NOTICE:

Install the same parts in the same combination to their original locations.



d.

Using SST, compress the inner compression spring and place the valve spring retainer lock around the valve stem.

SST
09202-70020  (09202-00010)


e.
A164832

Using a plastic-faced hammer, lightly tap the valve stem tip to ensure a proper fit.

NOTICE:

Be careful not to damage the valve stem tip.