Home › Engine / Hybrid System › 1GR-FE (FUEL) › FUEL INJECTOR
RM2660E _51 Engine / Hybrid System _052780 1GR-FE FUEL _0255076 FUEL INJECTOR A

1GR-FE FUEL  FUEL INJECTOR  INSTALLATION  


PROCEDURE

Hide 23250 1.INSTALL FUEL INJECTOR ASSEMBLY

a.
A223045E01
1.518,0.39 1.711,0.573 0.193,0.184 10 *1 2.203,1.573 2.396,1.756 0.193,0.184 10 *2 2.421,1.654 2.576,1.654 2.576,1.654 2.879,1.35 false 1.485,0.48 1.36,0.48 1.36,0.48 1.093,0.906 false

Install a new insulator to each fuel injector.

Text in Illustration
*1 New Insulator
*2 New O-Ring


b.

Apply a light coat of spindle oil or gasoline to new O-rings and install one to each fuel injector.


c.

Install the 6 injectors.

i.
A223046E01
0.682,0.279 0.861,0.444 0.179,0.165 10 *1 0.883,0.368 0.997,0.368 0.997,0.368 1.282,0.627 false

While turning each fuel injector left and right, install it to the fuel delivery pipe.

Text in Illustration
*1 Connector
V100135

Outward
V100136

Turn
V100137

Push


ii.

Position the fuel injectors with the connectors facing outward.



Hide 23807 2.INSTALL FUEL DELIVERY PIPE SUB-ASSEMBLY

a.

Place the fuel delivery pipe together with the 6 fuel injectors on the intake manifold.


b.

Temporarily install the 4 bolts, which are used to hold the fuel delivery pipe in place, to the intake manifold.


c.
U147593E01
2.362,1.437 2.537,1.604 0.174,0.167 10 *1

Check that the fuel injectors rotate smoothly.

Text in Illustration
*1 Turn

If the fuel injectors do not rotate smoothly, replace the O-ring of any injector that does not rotate smoothly.


d.

Position the fuel injectors with the connectors facing outward.


e.

Tighten the 4 bolts.

Torque:
21 N*m (214 kgf*cm, 15 ft.*lbf)


f.

Connect the 6 fuel injector connectors.


Hide 23802B 3.CONNECT NO. 2 FUEL PIPE SUB-ASSEMBLY

a.

Connect the No. 2 fuel pipe sub-assembly (See page Engine / Hybrid System>1GR-FE (FUEL)>FUEL SYSTEM>PRECAUTION).


Hide 23801P 4.CONNECT NO. 1 FUEL PIPE SUB-ASSEMBLY

a.

Connect the No. 1 fuel pipe sub-assembly (See page Engine / Hybrid System>1GR-FE (FUEL)>FUEL SYSTEM>PRECAUTION).


Hide 6.INSPECT FOR FUEL LEAK

a.

Make sure that there are no fuel leaks after performing maintenance on the fuel system.

i.

Connect the GTS to the DLC3.


ii.

Turn the ignition switch to ON and turn the GTS on.

NOTICE:

Do not start the engine.



iii.

Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.


iv.

Check that there are no leaks from the fuel system.

If there are fuel leaks, repair or replace parts as necessary.


v.

Turn the ignition switch off.


vi.

Disconnect the GTS from the DLC3.