Do not disconnect the hoses indicated in the illustration.
1.INSTALL NO. 1 FUEL SUCTION SUPPORT
Attach the 2 claws to the claw holes to install the No. 1 fuel suction support.
23070
2.INSTALL FUEL MAIN VALVE ASSEMBLY
Apply a light coat of gasoline to 2 new O-rings, and install them onto the fuel main valve assembly.
Install the fuel main valve assembly to the fuel filter case.
| *1 | O-Ring |
| *a | Fuel Filter Case |
Make sure the O-rings are not cut or pinched during the installation.
23221
3.INSTALL FUEL PUMP
Connect the fuel pump wire harness connector to the fuel pump.
Apply a light coat of gasoline to a new O-ring. Then install the spacer and O-ring to the fuel pump.
| *1 | O-Ring |
| *2 | Spacer |
Attach the 5 claws to the claw holes and install the fuel pump to the fuel filter case.
77131C
4.INSTALL NO. 1 FUEL SUB-TANK
Make sure that the fuel tube passes into the section marked by the circle.
| *a | Fuel Tube |
Attach the 3 claws to the claw holes and install the No. 1 fuel sub-tank.
Attach the 3 claws to the claw holes.
Connect the jet pump (labeled B) to the No. 1 fuel sub-tank.
| *a | Jet Pump |
Attach the claw on the end of the tube to the claw hole.
Connect the jet pump (labeled A) to the No. 1 fuel sub-tank.
Connect the fuel pump connector.
83320
5.INSTALL FUEL SENDER GAUGE ASSEMBLY