Home › Engine / Hybrid System › 1GR-FE (FUEL) › FUEL SENDER GAUGE ASSEMBLY › from 2015.08
RM2660E _51 Engine / Hybrid System _052780 1GR-FE FUEL _0255081 FUEL SENDER GAUGE ASSEMBLY G

1GR-FE FUEL  FUEL SENDER GAUGE ASSEMBLY  INSPECTION  


PROCEDURE

Hide 83320 1.INSPECT FUEL SENDER GAUGE ASSEMBLY

a.

Check the fuel sender gauge assembly output voltage.

i.
A349952E01
2.213,0.652 2.853,0.652 false 1.775,0.582 2.161,0.195 2.161,0.195 2.424,0.195 false 2.439,0.098 2.691,0.265 0.252,0.167 10 FE 2.901,0.57 3.153,0.738 0.252,0.167 10 FV 1.621,1.698 1.873,1.865 0.252,0.167 10 *b 0.054,0.025 0.306,0.193 0.252,0.167 10 *a

Apply 5 V between terminals 1 (FV) and 2 (FE).

Text in Illustration
*a Component without harness connected
(Fuel Sender Gauge Assembly)
*b Voltage applied between terminals

NOTICE:
·

Be careful when connecting the leads, as the fuel sender gauge assembly may be damaged if the leads are connected to the wrong terminals.

·

Do not apply more than 6 V to terminals 1 (FV) and 2 (FE).



HINT:

If a stable power supply is not available, use 4 1.2 V nickel-metal hydride batteries or equivalent.




b.
A367890E03
0.128,0.13 0.335,0.310 0.207,0.180 10 *a 0.365,1.667 0.512,1.847 0.147,0.180 10 F 0.162,4.035 0.318,4.215 0.157,0.180 10 E 1.221,0.825 0.716,0.701 0.716,0.701 0.544,0.701 false 0.232,0.6 0.504,0.780 0.272,0.180 10 FR 1.629,1.527 1.883,1.707 0.254,0.180 10 FE 0.988,1.751 0.537,1.751 false 0.76,4.333 0.468,4.127 0.468,4.127 0.343,4.127 false 1.725,0.928 1.725,1.505 false

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
2 (FE) - 3 (FR) Float position is F (upper) 4.25 to 4.61 V*
Float position is E (lower) 0.34 to 0.70 V*


*: The output voltage changes depending on the voltage applied to the terminals.

Text in Illustration
*a Component without harness connected
(Fuel Sender Gauge Assembly)

HINT:
·

Output voltage (F) = (0.850 x Voltage applied to terminals) to (0.922 x Voltage applied to terminals)

·

Output voltage (E) = (0.068 x Voltage applied to terminals) to (0.140 x Voltage applied to terminals)



If the result is not as specified, replace the fuel sender gauge assembly.