Home › Engine / Hybrid System › 1GR-FE (FUEL) › FUEL SENDER GAUGE ASSEMBLY (for Fuel Sub Tank) › from 2015.08
RM2660E _51 Engine / Hybrid System _052780 1GR-FE FUEL _0255082 FUEL SENDER GAUGE ASSEMBLY(for Fuel Sub Tank) G

1GR-FE FUEL  FUEL SENDER GAUGE ASSEMBLY(for Fuel Sub Tank)  INSPECTION  


PROCEDURE

Hide 83320B 1.INSPECT FUEL SENDER GAUGE ASSEMBLY

a.

Check the fuel sender gauge assembly output voltage.

i.
A372626E01
1.324,1.745 1.554,1.897 0.231,0.152 10 *b 1.109,0.076 1.340,0.228 0.231,0.152 10 *a 0.413,1.056 0.631,1.056 0.631,1.056 1.508,0.717 false 0.409,0.252 0.627,0.252 0.627,0.252 1.807,0.637 false 0.143,0.959 0.421,1.158 0.278,0.198 10 FV 0.154,0.156 0.431,0.354 0.278,0.198 10 FE

Apply 5 V between terminals 3 (FV) and 2 (FE).

Text in Illustration
*a Component without harness connected
(Fuel Sender Gauge Assembly)
*b Voltage applied between terminals

NOTICE:
·

Be careful when connecting the leads, as the fuel sender gauge assembly may be damaged if the leads are connected to the wrong terminals.

·

Do not apply more than 6 V to terminals 3 (FV) and 2 (FE).



HINT:

If a stable power supply is not available, use 4 1.2 V nickel-metal hydride batteries or equivalent.




b.
A369252E01
1.07,0.276 1.326,0.482 0.257,0.207 10 *a 0.382,3.051 0.639,3.258 0.257,0.207 10 F 0.469,4.135 0.726,4.342 0.257,0.207 10 E 0.518,3.148 0.736,3.148 0.736,3.148 1.034,3.303 false 0.615,4.226 0.833,4.226 0.833,4.226 1.09,4.39 false 2.888,0.794 3.144,1.001 0.257,0.207 10 FR 2.922,1.585 3.178,1.791 0.257,0.207 10 FE 2.837,0.878 2.614,0.878 2.614,0.878 2.1,1.148 false 2.882,1.666 2.658,1.666 2.658,1.666 1.834,1.204 false

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
2 (FE) - 1 (FR) Float position is F (upper) 4.25 to 4.61 V*
Float position is E (lower) 0.34 to 0.70 V*


*: The output voltage changes depending on the voltage applied to the terminals.

Text in Illustration
*a Component without harness connected
(Fuel Sender Gauge Assembly)

HINT:
·

Output voltage (F) = (0.850 x Voltage applied to terminals) to (0.922 x Voltage applied to terminals)

·

Output voltage (E) = (0.068 x Voltage applied to terminals) to (0.140 x Voltage applied to terminals)



If the result is not as specified, replace the fuel sender gauge assembly.