Home › Engine / Hybrid System › 3UR-FE (FUEL) › FUEL PRESSURE REGULATOR › 2014.08–2015.08
RM2660E _51 Engine / Hybrid System _052781 3UR-FE FUEL _0255088 FUEL PRESSURE REGULATOR A

3UR-FE FUEL  FUEL PRESSURE REGULATOR  INSTALLATION  


PROCEDURE

Hide 23280 1.INSTALL FUEL PRESSURE REGULATOR ASSEMBLY

a.
A183091

Apply a light coat of gasoline or spindle oil to a new O-ring, and install it to the pressure regulator.

NOTICE:
·

Make sure that there are no scratches or foreign matter in or around the insertion hole of the delivery pipe.

·

When inserting the injector, be careful not to damage the O-ring.




b.

While turning the pressure regulator left and right, install it to the delivery pipe.


c.

Install the 2 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


d.

Connect the vacuum sensing hose to the pressure regulator.


e.

Connect the No. 2 fuel tube to the pressure regulator (See page Engine / Hybrid System>3UR-FE (FUEL)>FUEL SYSTEM>PRECAUTION).


Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).