Home › Engine / Hybrid System › 3UR-FE (FUEL) › FUEL SENDER GAUGE ASSEMBLY › from 2015.08
RM2660E _51 Engine / Hybrid System _052781 3UR-FE FUEL _0255094 FUEL SENDER GAUGE ASSEMBLY G

3UR-FE FUEL  FUEL SENDER GAUGE ASSEMBLY  INSPECTION  


PROCEDURE

Hide 83320 1.INSPECT FUEL SENDER GAUGE ASSEMBLY

a.

Check the fuel sender gauge assembly output voltage.

i.
A349952E01
2.213,0.652 2.853,0.652 false 1.775,0.582 2.161,0.195 2.161,0.195 2.424,0.195 false 2.439,0.098 2.691,0.265 0.252,0.167 10 FE 2.901,0.57 3.153,0.738 0.252,0.167 10 FV 1.621,1.698 1.873,1.865 0.252,0.167 10 *b 0.054,0.025 0.306,0.193 0.252,0.167 10 *a

Apply 5 V between terminals 1 (FV) and 2 (FE).

NOTICE:
·

Be careful when connecting the leads, as the fuel sender gauge assembly may be damaged if the leads are connected to the wrong terminals.

·

Do not apply more than 6 V to terminals 1 (FV) and 2 (FE).



HINT:

If a stable power supply is not available, use 4 1.2 V nickel-metal hydride batteries or equivalent.


Text in Illustration
*a Component without harness connected
(Fuel Sender Gauge Assembly)
*b Voltage applied between terminals



b.
A367890E02
1.208,0.833 0.719,0.833 false 1.719,0.938 1.719,1.479 false 1.031,1.708 0.479,1.708 false 0.75,4.344 0.5,4.344 false 0.083,0.083 0.375,0.344 0.292,0.26 10 false *a 0.469,0.75 0.802,0.99 0.333,0.24 10 false FR 1.625,1.479 1.958,1.719 0.333,0.24 10 false FE 0.385,1.615 0.656,1.823 0.271,0.208 10 false F 0.385,4.271 0.646,4.479 0.26,0.208 10 false E

Measure the voltage according to the value(s) in the table below.

Text in Illustration
*a Component without harness connected
(Fuel Sender Gauge Assembly)

Standard Voltage:
Tester Connection Condition Specified Condition
2 (FE) - 3 (FR) Float position is F (upper) 4.25 to 4.61 V*
Float position is E (lower) 0.34 to 0.70 V*


*: The output voltage changes depending on the voltage applied to the terminals.

HINT:
·

Output voltage (F) = (0.850 x Voltage applied to terminals) to (0.922 x Voltage applied to terminals)

·

Output voltage (E) = (0.068 x Voltage applied to terminals) to (0.140 x Voltage applied to terminals)



If the result is not as specified, replace the fuel sender gauge assembly.