1. PRECAUTION
After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
71300S
3.REMOVE REAR NO. 1 SEAT ASSEMBLY RH (for 60/40 Split Seat Type 40 Side)
71400S
4.REMOVE REAR NO. 1 SEAT ASSEMBLY LH (for 60/40 Split Seat Type 60 Side)
5.REMOVE REAR NO. 2 SEAT ASSEMBLY
for Face to Face Seat Type:
(See page Vehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY(for Face to Face Seat Type)>REMOVAL)
except Face to Face Seat Type:
(See page Vehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY(except Face to Face Seat Type)>REMOVAL)
58570C
6.REMOVE REAR FLOOR MAT ASSEMBLY
Detach the 5 clips and fold back the rear floor mat assembly toward the front of the vehicle.
Fold back the rear floor mat assembly so that the rear No. 7 air duct can be removed.
87212L
7.REMOVE REAR NO. 7 AIR DUCT
Detach the 4 clips and remove the rear No. 7 air duct.
58325E
8.REMOVE REAR FLOOR SERVICE HOLE COVER
83320B
9.REMOVE FUEL SENDER GAUGE ASSEMBLY
Disconnect the fuel sender gauge connector.
Remove the 5 screws and fuel sender gauge assembly.
Be careful not to bend the arm of the fuel sender gauge assembly.
Remove the gasket from the fuel sender gauge assembly.